J4C KIT DPS 20 Instrucciones Montaje página 13

ASSEMBLY INSTRUCTIONS KIT DPS 140/300 ASSEMBLY INSTRUCTIONS KIT DPS 140/300
ENGLISH ENGLISH
- -
The DPS is a device for the J4C electric actuator
that turns the actuator into a servo controlled
valve positioner.
The DPS is a modulus with a microprocessor (CPU)
which digitally manages the analogical input and
output and compare them with the position of the
actuator to establish a uniform relation.
The analogical inputs are sent to the CPU where
they are processed for his continuous comparison
with the position of the actuator, this allows to
obtain a very high sensitivity next to a very high
repetitivity of the position (see characteristics).
The DPS in communication with the electronic
system of the actuator provides an integral mana-
gement of the motion of the actuator.
PIECES
A
- 1 Cover
B - 1 Plastic column
C - 1 DPS positioner PCB
D
- 2 Sheet metal Fixing screws
E - 1 Plastic Fixing screws
F - 1 Schematic diagram label
PLEASE READ CAREFULLY BEFORE MOUNTING.
VERY IMPORTANT!!!! PLEASE FOLLOW THE INSTRUCTIONS STEP BY STEP. BEFORE CONNECTING "A"
PLUG TO THE ACTUATOR, CHECK THAT THE VOLTAGE IS THE SAME AS THE ONE SPECIFIED ON THE
LABEL (CARTER).
TO CONVERT A STANDARD (ON-OFF) J4C ELECTRIC ACTUATOR INTO A MODULATING FUNCTION WITH
POSITIONER, PROCEED AS FOLLOWS:
DPS 140/300
OUTSIDE BOX
A
INSIDE BOX
B
C
D
E
F
02