J4C KIT DPS 20 Instrucciones Montaje página 5

ASSEMBLY INSTRUCTIONS KIT DPS 20/85
ENGLISH
-
16. Use the configuration you need by moving the DIPs, according to the instrumentation signal (Fig. 15)
17. Care-fully mount the cover, minding the cables not to be pressed (Fig.16).
18. Fix the cover to the body by using the 6 screws (Fig. 17).
19. Mount the hand wheel on the shaft and fix it by using the screw (Fig. 18).
20. Mount the 3 outer connectors together with its rubber joints and fix them to the cover, by using the
screws (Fig. 19).
21. Fill in the document inside the kit, and send it to the fax number or e-mail, shown in the document
The unit is ready to work.
Outer Set-Up: Only if necessary.
- B plug - Connect a cable between PIN 1 and PIN Earth (Fig. 20).
- A plug - Connect it to the power supply.
- B plug, disconnect the cable between PIN 1 and PIN Earth.
The actuator will make a complete maneuver.
Connect B connector to the actuator. The actuator is ready to work.
DPS 20/85
04