Panasonic DMR-E500H Manual De Instrucciones página 78

Troubleshooting guide
Edit
Cannot format.
Cannot create chapters.
Cannot mark the start point or
the end point during "Partial
Erase" operation.
Cannot erase chapters.
The available recording time
doesn't increase even after
erasing recordings on the
disc.
Cannot create a play list.
Still pictures and MPEG4
Cannot display Direct
Navigator screen.
Cannot edit or format a card.
The contents of the card
cannot be read.
Transferring (dubbing),
erasing and setting protection
takes a long time.
The PC card cannot be
removed.
Network
The network function will not
run.
∫ To initialize this unit's network password
While the disc tray is open, press [DVD] then press and hold [D] and [TIME SLIP] on the main unit at the same time for 5 or more
seconds ("INIT" will appear on the unit's display). The password setting will be erased. If "Network Function" is set to "Disable" the password
cannot be erased (➡page 65).
RQT7751
78
78
All manuals and user guides at all-guides.com
≥The disc is dirty. Use a special cleaner and wipe clean.
≥You tried formatting a disc that is not compatible with this unit.
≥The unit writes the chapter information to the disc when you turn it off or remove the disc.
The information is not written if there is an interruption to the power before this.
≥These operations are not possible with still pictures.
≥You cannot set points if they are too close to each other. You cannot set an end point before
a start point.
≥When the chapter is too short to erase, use "Combine Chapters" to make the chapter
longer.
≥Available recording space on the DVD-R does not increase even after erasing previously
recorded titles.
≥You cannot select all the chapters at once in a title if the title also includes still pictures.
Select them individually.
≥This screen cannot be displayed during recording or transfer (dubbing) or while the unit is
standing by for linked timer recording with external equipment.
≥Release the card's protection setting. (With some cards, the "Write Protection Off" message
sometimes appears on the screen even when protection has been set.)
≥The card format is not compatible with the unit. (The contents on the card may be
damaged.)
Format using FAT 12 or FAT 16 with other equipment or format the card with this unit.
≥The card contains a folder structure and/or file extensions that are not compatible with this
unit.
≥Turn off and then turn on the unit again.
≥When there are a lot of folders and files, it may sometimes take a few hours.
≥When repeating transferring (dubbing) or erasing, it may sometimes take a long time.
Format the disc or card.
≥Make sure the PC card is slotted home firmly before attempting to remove.
≥When using a wireless router, operations may be being affected by local signal conditions
(weak radio waves or the network environment).
≥Turn off the DVD recorder operated via the Network.
≥Check the router setting (DHCP server and the security settings etc.). Read the router's
operating instructions for further information.
≥There may be limits to your usage of the router by your telecommunications carrier or
Internet service provider. Please contact the telecommunications carrier or Internet service
provider that you subscribe to.
≥Enter the IP address correctly if operating by computer.
≥Make sure the LAN cable is properly connected.
≥Make sure the client units are registered.
≥The server cannot transmit data to more than one place at the same time (e.g. more than
one client, a client and a computer and so on).
≥Please check the connection.
Select the "Network" tab in the SETUP menu. Press and hold [ENTER] for more than 5
seconds. Operation is possible when the display changes from "Now updating the settings"
to "Now connected to the network".
Page
79
21
—
—
—
41
—
—
—
60
22, 34
61
70
—
—
61
34
—
—
—
—
57
11
20
—
—