Starting Production; Filling Cavity With Water; Filling The Pot - Apach E50I77 Instrucciones Para El Funcionamiento

5. 3.
INSTRUCTIONS FOR USE

Starting production

Before proceeding with these operations, see "Daily
activation".
When loading the product into the appliance and
unloading it, there is a residual risk of being burnt; this
risk can occur coming into unintentional contact with:
cooking compartment - hob - recipients or material
processed.
Take appropriate measures for personal protection.
Wear protective equipment suitable for the operations
to be performed.
It is strictly forbidden to use the pot as a fryer.
The appliance must be used with tap water inside
the cavity. Any other use is improper and therefore
dangerous.
The appliance must be used with tap water inside the
cooking compartment. Any other use is improper and
therefore dangerous.

Filling Cavity with Water

Turn the knob to the drain position (Open) to drain water from the
cavity (Fig. 1 A).
Turn the gate valve to the filling position (Open) to fill the cavity
with water (Fig. 2 A).
Check daily for water in the cavity, and if present, act
on the filling gate valve and on the control drain.
The cavity holds approximately 14 litres for the
700, and for the 900-980 either 33 or 37 litres, ac-
cording to the model.
You will know the cavity is completely full when wa-
ter comes out of the control drain (Fig. 1 B1).
When filling is complete, simultaneously close the filling gate
valve and the water control drain in the cavity (Fig. 1-2 B ).
Having successfully filled the cavity with water, proceed filling the
pot.

Filling the Pot

Make sure that the cooking compartment drainage gate valve is at
the "Closed" position (Fig. 3).
The drainage gate valve opens by lifting the handle
and turning it 90°/180° (Fig.3A -3B) respect to the
closed position (Fig.3).
Lift the lid of the pot and fill the cooking compartment with the
material to be processed.
THE PRESENT MANUAL IS PROPERT Y OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
A
1
Fig.
A
2
Fig.
A
90° = 50%
3A
Fig.
- 10 - - 10 - 10 10
B
B1
B
Dx. 0° = 0%
3
Fig.
180° = 100%
3B
Fig.