Switching On/Off - Apach E50I77 Instrucciones Para El Funcionamiento

3. 5.
INSTRUCTIONS FOR USE
When filling the cooking compartment, respect the
maximum level indicated on the inside.
Do not introduce large pieces of kitchen salt into the
cooking compartment as it deposits at the bottom and
does not completely dissolve.
Hot or cold water can be introduced into the cooking
compartment by acting on the 2 knobs (Fig.4).
In order to fill the cooking compartment with water, you must:
• Lift the lid of the cooking compartment if necessary.
• Turn the pipe in the direction of the cooking compartment
(Fig. 5).
• Open the water filling knob at the desired position (hot-cold-
both) (Fig. 4A) and fill the tank as needed.
• Close the knob/s when filling is complete (Fig.4B).
• Reposition the pipe so it does not get in the way of the lid
when it closes (Fig. 5).

Switching On/Off

The appliance must be switched on after having filled
the cavity with water. Do not switch it on when empty
(see previous page).
The appliance must be switched on after having filled
the cooking compartment with water. Do not switch it
on when the cooking compartment is empty.
Having successfully performed the water filling operations,
proceed with the "Switch On/Off" procedure as follows:
Turn the switch-on knob to "1-2-3" as required. The green
indicator light will turn on signalling the operating phase (Fig. 6 A).
Turn the knob to "Zero" (Fig. 6 B) to switch the appliance off at
the end of the work cycle.
THE PRESENT MANUAL IS PROPERT Y OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
A
B
A
- 11 - - 11 - 11 11
Fig.4
A
B
Fig.5
A
B
Fig.6