10.1 The coffee dispenser
The coffee dispenser (18) must be
cleaned each time you fill the coffee
bean container or at least once a week.
• Switch off the espresso maker by pressing the
ON/OFF switch (8) to the OFF position and
remove the plug from the wall outlet.
• Open the access door (16). Remove the drip
tray (13) and the coffee grounds drawer.
• Remove the coffee dispenser by holding it by
its handle and pressing the "PUSH" button
(Fig.22)
• Make sure that the two steel filters are free
from any coffee residues. The top filter can
be removed by unscrewing the plastic pin
counter clockwise using the specific supplied
key (Fig.23).
• Wash the coffee dispenser only with hot water:
do not use detergents. Then accurately wash
and dry all its components. NEVER PUT INTO
A DISHWASHER.
• Refit the filter and carefully screw the plastic
pin back on using the specific key.
• Clean the compartment inside the appliance.
• Holding it by its handle, insert the coffee
dispenser into its housing until it snaps into
place.
• Insert the coffee grounds drawer, the drip tray
plate and the drip tray.
• Close the access door (16).
11 DESCALING
Scaling occurs naturally when the appliance is
used. Approximately every 3-4 months you
should descale it; it is ready for descaling when
you notice a reduction in the water flow or when
the descale button (27) flashes.
If you wish to carry this out at home,
you can use a descaling product for
coffee makers that is non toxic and/or not
harmful and commonly available on the
market.
We recommend the Starbucks Barista
Cleaner and Descaler.
Caution! Never use vinegar.
Questions? Call us at 1.866.723.2648
All manuals and user guides at all-guides.com
To descale the appliance proceed as follows:
• Mix the descaler with water as specified on
the package and fill the water tank.
• Switch ON the appliance.
• Press the descale button (27) for at least 5
seconds to select the descaling operating
mode; the button emits a fixed light.
• Direct the steam wand (15) towards the drip
tray.
• Position a cup of adequate capacity under the
steam wand and turn the steam knob counter
clockwise (17). The espresso maker starts an
automatic descaling cycle with pauses preset
by the manufacturer and managed
automatically by the machine.
• At the end of the cycle, the flow of the
descaling solution is shut off and the 5 buttons
start flashing simultaneously.
• Turn the knob of the hot water wand (17)
clockwise to OFF. In this case, also the warning
light (28) flashes.
• Rinse the water tank and fill it with fresh
drinking water.
• Position a cup of adequate capacity under the
steam wand and empty 2/3 of the contents of
the water tank by turning the steam knob (17)
counter clockwise; to shut off the flow, turn
the knob (17) clockwise.
• Let the espresso maker heat up and empty
the remaining contents of the water tank by
turning the steam knob (17) counter clockwise;
to stop the flow, turn it clockwise.
If you use a different product from
the
recommended
recommend you follow the instructions of
the descaler manufacturer as specified on
the package.
If the descaling cycle is interrupted
by switching the machine OFF, this is
restarted when the machine is switched back
ON.
12 LEGAL INFORMATION
• This instruction book contains the necessary
information to use and upkeep your appliance
correctly.
• The information should be viewed as a
ENGLISH
one,
we
• 15 •