Your Dvb-T Receiver; Front Panel; Rear Panel - Strong SRT 5150 Manual Del Usuario

5150 UM-B5 12/22/04

2.0 Your DVB-T Receiver

2.1 Front Panel

1. Power Button
2. Stand-BY / ON / SIGNAL (3 LEDs) The red LED is the "stand-by" indicator. The green LED is the
3. UP/DOWN
4. LED Display

2.2 Rear Panel

1. ANTENNA INPUT
2. RF OUTPUT
3. AUDIO Right (Red RCA)
and Left (White RCA)
4. VIDEO (Yellow RCA)
5. TV Scart Connector
6. VIDEO Scart Connector
7. IR SENSOR
8. RS232 Serial Port
Note: It is recommended to ONLY use the original software provided via our website. Loading other ver-
sions of software not adapted to your model number can cause severe damage to your receiver, and
will not be covered by the warranty.
9. S/PDIF
10. Power Supply
6
All manuals and user guides at all-guides.com
5:27 PM Page 6
(Please see inside cover Figure 1)
Turns the receiver ON/OFF.
"Power On" indicator. The orange LED lights up once you correctly receive a
antenna signal (signal locked)
Buttons Move the cursor UP/DOWN in Menu state. Changes the channels
UP/DOWN in no menu state.
This 4-digit LED panel indicates the time or the program number.
(Please see inside cover Figure 2)
Connect the antenna cable to this connector.
Gives you the possibility to connect the receiver to TV by RF cable.
These connectors give you the possibility to connect the audio signal to an
external amplifier or to the audio input of your TV.
This connector has a constant video signal for additional VCR-connections.
Use this connector to connect your receiver to your TV using a scart cable.
Use this connector to connect your receiver to your video recorder using a
scart cable. Your video signal will now be looped through to your TV.
Use this connector to connect an external remote eye if you wish to store
your receiver in a place where the IR on your receiver cannot communicate
with the remote. For example, if you wish to put your receiver in a closed
environment such as a well ventilated closet, then this accessory will be
useful because it can allow the remote control to control the receiver through
the remote eye.
This serial port can be used to connect your PC to your receiver, and enables
you to download new versions of software into your receiver. Detailed
information about downloading software into your receiver can be found on
our website (www.strongsat.com).
Use this coaxial output to connect your receiver to the input of your digital
audio amplifier.
Your receiver requires a mains voltage supply of 90~240V AC, 50~60 Hz +/-
5%. Make sure to check the power specification of the wall outlet before con-
necting your receiver to the main power.
PART 1 • English