Connection To A Digital Audio Amplifier Using The S/Pdif Output; Connecting A Remote Eye; Connecting A Serial Cable For Downloading Software; Starting Up - Strong SRT 5150 Manual Del Usuario

5150 UM-B5 12/22/04

3.1.5 Connection to a digital audio amplifier using the S/PDIF output

(Please see inside cover Figure 8)
Connect the S/PDIF out connector on the back of your receiver to the S/PDIF input connector of
your digital amplifier, using a coaxial cable.
Do not forget to turn the S/PDIF function on (Main menu > Installation >PIN code "0000">
TV/VCR Settings > SPDIF Output > On)

3.1.6 Connecting a remote eye

Connect the IR sensor to your remote eye if you wish to store your receiver in a place where the
IR on your receiver cannot communicate with the remote.
For example, if you wish to put your receiver in a closed environment such as a well ventilated closet, then this
accessory will be useful because it can allow the remote control to control the receiver through the remote eye.

3.1.7 Connecting a serial cable for downloading software

(Please see inside cover Figure 10)
Connect the RS 232 connector on the back of your receiver to the Serial port of your computer
using a serial cable.
Instructions on how to download software can be found on our website www.strongsat.com
(support > downloads).

4.0 Starting up

Ensure that your terrestrial receiver is correctly connected to your television and your antenna, and that your
antenna signal is of good quality. (If you are not sure about this then ask your local Strong dealer to check
your installation or antenna signal).

4.1 Starting up for the First Time

Connect your DVB-T receiver as under point 3 described.
Enter the present menu < System-Setup / Language setting /Menu language>. Press OK button to
confirm your selection. Press the Back button until you go back to installation menu.
Follow the path < Installation / (PIN '0000') / Country Selection >. Select country and press OK but-
ton. Once selection is confirm "Country Selected Sucessfully" appears.
Follow the path < Installation / (PIN '0000')/ Channel Set-Up/Auto Scan > to select the automatic
scan search option for all available TV and Radio programmes. Press OK button to confirm your
selection and wait. Press the Back button until you go back to main menu.
Note: It is important to select the correct country inside the menu before the scanning process starts to avoid
scanning problems.
8
All manuals and user guides at all-guides.com
5:27 PM Page 8
(Please see inside cover Figure 9)
PART 1 • English