Safety Notes; Important Notes; Functions; Information About Operation - LGB 21428 Manual De Instrucciones

Safety Notes

• This model may only be used with the operating system designed for it.
• Use only switched mode power supply units and transformers that are designed
for your local power system.
• This locomotive must never be supplied with power from more than one power
pack.
• Pay close attention to the safety notes in the instructions for your operating sys-
tem.
• Not for children under the age of 15.
• WARNING! Sharp edges and points required for operation.

Important Notes

• The operating instructions are a component part of the product and must therefore
be kept in a safe place as well as included with the product, if the latter is given to
someone else.
• The warranty card included with this product specifies the warranty conditions.
• Please see your authorized LGB dealer for repairs or spare parts.
• Disposing: www.maerklin.com/en/imprint.html
• Due to the special surface of the body and several separately parts, special cau-
tion is required when handling this locomotive. Fingerprints can stand out on the
shiny parts. Please note that no cleaning solutions or rough cloths may be used
to clean this model. Individual damaged parts can be exchanged at the Märklin
repair service.

Functions

• This model is designed for operation on LGB two-rail DC systems with conventio-
nal LGB DC train controllers or power packs (DC, 0 - 24 volts).
• Factory-installed multiple protocol decoder (DC, DCC, mfx).
• The model is programmed with locomotive address 03 for use with the LGB Multi
Train System (DCC). The locomotive is automatically recognized in operation with mfx.
• Volume can be changed for the sound effects
• The functions can be activated only in parallel. Serial activation of the functions is
not possible (Please note here the instructions for your controller).
General Note to Avoid Electromagnetic Interference:
A permanent, flawless wheel-rail contact is required in order to guarantee operation
for which a model is designed. Do not make any changes to current-conducting parts
All manuals and user guides at all-guides.com
Mode of Operation Switch
This locomotive has a 4-position mode of operation switch (Figure 1).
Pos. 0
Pos. 1
Pos. 2
Pos. 3
Setting U: Current from the rails
Setting O: Catenary operation
Catenary Power Operation
This locomotive can be operated with a powered catenary system (see Operating
Modes). The bottom of this model is marked with a red dot. Place the model on the
track with the red dot pointing to the rail that is not connected to the catenary power
supply (Figure 2).
CAUTION! Catenary may be supplied with current only in analog operation. In digital
operation, the locomotive may only receive current from the rails, since otherwise
dangerous voltage levels may be generated.
Sound
This model has a volume control on the underside (Fig3).
The whistle can also be activated with the LGB sound activating magnets (17050).
The activating magnet can be clipped into place between the ties on most sections
of LGB track.
Place the logos with the logo on the right side or left side of the track respectively in
order to activate a short blast / long blast on the whistle when the locomotive crosses
over this spot.
Pantographs
This model is equipped with electronically controlled pantographs. The rear pan-
tograph is raised and the front pantograph is lowered automatically depending on
the direction of travel (Function 7). The pantographs can also be optionally raised
manually (Function 3). Function F7 is active in analog operation.
The pantographs can be fixed in the lowered position by clipping them into the
restraints.
10
Locomotive stopped without current
Locomotive motors and lighting are turned on
Locomotive motors and lighting are turned on
Locomotive motors and lighting are turned on