Stel TIG μP 253H AC/DC Manual De Instrucciones página 64

TIG µP 253H AC/DC
TECHNICAL DESCRIPTION
INTRODUCTION:
- Gas Tungsten Arc Welding (GTAW) is the definition of the welding process in
which the arc, during work, is maintained by means of an infusible metal electrode
(usually tungsten). The arc area (electrode and weld pool) is protected against
atmospheric contamination by means of an inert gas such as argon or helium,
which flows continuously through special ducts connected to the torch.
For the sake of simplicity and uniformity, all references to the process in this
manual are made with the term TIG (Tungsten Inert Gas).
- This process may be used for making clean and precise welds on any type of
metal, respecting its physical and chemical composition.
Thanks to this characteristic, TIG welding is the only method suitable for joining
certain metals.
- Due to the characteristics of the TIG process, the design of the welding machine
must satisfy specific requirements. TIG welding machines are designed and built
with these provisions. If they are installed, used and maintained correctly, they can
give long and satisfactory service, making correct, clean welds.
64
ENGLISH
COD. 6910000030
STEL s.r.l. – Via del Progresso n° 59 – 36020
Loc. Castegnero (VICENZA) - ITALY
TEL. +39 444 639525 (central.) – +39 444 639682 (comm.)
FAX +39 444 639641 – E-mail:stelgroup.com
http: www.stelgroup.it
TIG µP 253H AC/DC
TECHNICAL DESCRIPTION
INTRODUCTION:
- Gas Tungsten Arc Welding (GTAW) is the definition of the welding process in
which the arc, during work, is maintained by means of an infusible metal electrode
(usually tungsten). The arc area (electrode and weld pool) is protected against
atmospheric contamination by means of an inert gas such as argon or helium,
which flows continuously through special ducts connected to the torch.
For the sake of simplicity and uniformity, all references to the process in this
manual are made with the term TIG (Tungsten Inert Gas).
- This process may be used for making clean and precise welds on any type of
metal, respecting its physical and chemical composition.
Thanks to this characteristic, TIG welding is the only method suitable for joining
certain metals.
- Due to the characteristics of the TIG process, the design of the welding machine
must satisfy specific requirements. TIG welding machines are designed and built
with these provisions. If they are installed, used and maintained correctly, they can
give long and satisfactory service, making correct, clean welds.
64
ENGLISH
COD. 6910000030
STEL s.r.l. – Via del Progresso n° 59 – 36020
Loc. Castegnero (VICENZA) - ITALY
TEL. +39 444 639525 (central.) – +39 444 639682 (comm.)
FAX +39 444 639641 – E-mail:stelgroup.com
http: www.stelgroup.it