Customer Service - Peg-Perego Pliko P3 Pramette Instrucciones De Uso

EN•ENGLISH
• IMPORTANT: carefully read instructions and keep
for future use.
The childʼs safety could be put at risk if the
instructions are not followed.
• PEG PEREGO reserves the right to make any
necessary changes or improvements to the products
shown at any time without notice.
Peg Perego S.p.A. is an ISO 9001 certified
company.
The fact that we are certified provides
a guarantee of our honesty for our
customers, and fosters trust in the
companyʼs way of working.

CUSTOMER SERVICE

If parts of the model are accidentally lost or damaged,
use only original Peg Perego spare parts. Contact
the Peg Perego Customer Service for all repair work,
replacements, information about products, and sale of
original spare parts and accessories, at the following:
tel.: 0039-039-60.88.213
fax: 0039-039-33.09.992
e-mail: assistenza@pegperego.it,
www.pegperego.com
Peg Perego is at the consumer's service, meeting
every need in the best way possible. This is why our
customers' opinions are so important and valuable
to us. We would be very grateful if you would kindly
fill in the CUSTOMER SATISFACTION QUESTIONNAIRE
after using one of our products. You will find the
questionnaire on the Internet at "www.pegperego.
com/SSCo.html.en-UK".
Please note any observations or suggestions you may
have on the questionnaire.
INSTRUCTIONS FOR USE
OPENING
1• Before opening the stroller remove the two
protective caps from the hooks as shown in the
figure. Otherwise, the stroller will not open correctly.
2• To open the stroller, pull up the two levers on the
handles and
3• at the same time, lift the stroller, which will open
automatically. To make sure that the stroller has
been set up correctly, check the two side hooks
(see figure).
ASSEMBLYING THE STROLLER
4• To mount the front wheels, lower Lever A and slip
the wheels onto the axle, as shown in the figure.
Press until the wheels click into place.
5• To assemble the rear wheels fasten the wheels
connected by the break wire, as indicated in the
figure.
6• Carefully distinguish the left wheel from the right,
to fasten the two rear wheels properly. The left
wheel has a rib on the wheel tube and one on the
chassis to guarantee proper fastening (see figure).
7• Make sure that it is fastened properly, as indicated
in the figure (click).
8• To mount the basket, slide the slots onto the front
hooks A and the rear hooks B and C.
9• The figure shows the mounted basket.
10• The drink-holder can be attached to the left or the
right handle of the stroller, using the two bands.
• To mount the drink-holder to the handle, widen
the clamp and fasten as shown in the figure.
11• Slide the clamp in the drink-holder until it clicks.
All manuals and user guides at all-guides.com
12• The stroller comes with caps on the armrests. To
13• To mount the front bar, press the buttons while
14• To place the front bar in the first position (1),
15• To remove the front bar, press the two buttons
16• To apply the brakes, push down with one foot the
17• A: Make sure that the brace is properly inserted by
18• To unfasten the belt, press on the buckle sides
19• The new safety belt is now easier to fasten thanks
20• The footboard can be adjusted to three different
21• The backrest can be reclined in four positions. To
22• To make the front wheels swivel, push down as
23• The height of the handles can be adjusted in two
24• The rear ledge helps overcome small rises and can
25• To use the stroller with two children, brake the
Do not put hot drinks in the drink-holder, nor
items weighing more than 1 kg (2.2 lbs).
FRONT BAR
attach the front bar, remove the caps first. (Keep the
caps, in case you want to use the stroller without the
front bar). To remove the caps, press the buttons
under the armrests while pulling the caps off.
slipping the front bar onto the armrests, as shown in
the figure. Push until the armrest clicks into place.
The armrest will now be in the second position (2).
press the buttons under the armrests while
pushing the front bar towards the stroller.
under the armrests while pulling the front bar out.
(The front bar will click into the second position).
Press the buttons again, and pull the front bar off
the stroller. The front bar can be opened on one
side only to allow the child to get in and out of the
stroller more easily when he is older.
BRAKE
bars on the rear wheels, as shown in the figure.
To release the brakes, draw the bar up. Always set
the brakes on the stroller when it is not in motion.
SAFETY BELT
pushing as shown in the figure. B: Fasten the belt
as shown in the figure.
and pull out the waist strap.
to the "snap-open-and-shut" device. Before
fastening the safety belt, attach the buckle to the
backrest by inserting the tab through the special
holder, as shown in the figure. After fastening
the safety belt on your child, detach it from the
backrest to allow the child more freedom of
movement. The buckle must remain below the
child's shoulders.
ADJUSTING THE FOOTBOARD
positions. To lower the footboard, pull the two
small levers downward while lowering. To lift the
footboard, pull it up until it clicks into place. This
is the third, highest position (see figure) for the
baby carriage version of Pliko P3-Pramette.
ADJUSTING THE BACKREST
lower the backrest, raise the handle as you lower
the backrest, blocking it in the desired position.
To raise it, push the backrest upward.
SWIVELLING WHEELS
shown in the figure. To fix the wheels, pull up the
lever.
ADJUSTING THE HANDLES
positions. For the upper position, press the button
as you raise the handle. To lower it, press the
button as you lower the handle.
REAR LEDGE
also be used to carry a second child.
LOADING SEQUENCE
stroller, place the smaller child in the seat and