Safety Instructions For Batteries; Preparation; Required Tools And Material; Prior To Installation - LIVARNO LUX 9000.034.080 072017-8 Instrucciones De Montaje

Safety / Preparation / Prior to installation
Prevent fire and risks
of injury
Do not leave the light or packaging lie about
carelessly. Plastic film or bags, plastic parts,
etc. are dangerous for children to play with.
Do not cover the lamp with objects. Excessive
heat can result in fire.
Safe working
Mount the light so it is protected from moisture
and dirt.
Carefully prepare for assembly and allow your-
self adequate time. First organise all parts or
materials so they are easy to reach.
Always be attentive! Always pay attention to
what you are doing and proceed with caution
at all times.
Never assemble the lamp whilst unfocused or
feeling unwell.

Safety Instructions for batteries

Never expose batteries to excessive heat such
as sun, fire, etc. The batteries may explode!
Never recharge non-rechargeable batteries.
Explosion hazard!
Keep batteries away from children, do not
short-circuit or take apart.
Replace all batteries in a set. Only use the same
types of batteries together, never mix types or
used and new batteries.
Clean battery contacts and the contacts inside
the device before inserting the batteries.
Be sure to insert the batteries correctly, i.e. note
the polarity (+ and –).
Remove drained batteries immediately.
Increased risk of leaks!
Avoid battery fluid coming into contact with the
skin, eyes and mucous membranes. In the event
of contact, immediately rinse the affected area
with plenty of clear water and seek immediate
medical attention.
16 GB/IE

Preparation

Required tools and material

The tools and materials specified are not included.
This information and these values are non-binding
and are only provided as a reference. The nature
of the material is determined by the individual local
conditions.
– Pencil / marking tool
– Voltage tester
– Screwdriver
– Electric drill
– Drill bit (approx. Ø 6 mm)
– Hammer
– Side cutter
– Ladder

Prior to installation

Important: The electrical connection must be per-
formed by a trained electrician or a person instructed
in electrical installation. This person must be familiar
with the properties of the light and connection reg-
ulations.
Familiarise yourself with all the instructions and
illustrations in this manual, as well as with the
light itself, before installing it.
Prior to installation, verify the circuit to which the
light will be connected is not energised. To do so,
remove the fuse or switch off the circuit breaker
in the fuse box (0 position).
Use the voltage tester to verify the de-ener-
gised status.
Unpack the LED Ceiling lights
stable surface (be careful that they don't
become scratched).
Take hold of the plastic cover with two hands
and gently press on the stable surface. Now
turn the plastic cover
stops (in the opposite direction of the arrow)
and remove the plastic cover
bottom up.
and lay on a
12
2
anti-clockwise until it
2
from the
2