Initial Use; Mounting / Installation Of The Light; Installing The Wall Bracket; Inserting / Replacing Batteries - LIVARNO LUX 9000.034.080 072017-8 Instrucciones De Montaje

Initial use

Mounting / installation of the
light (see Fig. A–I)
Before installation ensure that the circuit, to
which the light will be connected, is not ener-
gised. To do so, remove the fuse or switch off
the circuit breaker in the fuse box (0 position).
Mount the light fixture
tion. While doing so, observe the drill hole in
the light fixture through which the power
1
cable is introduced.
Mark three drill holes
Drill the holes. Be sure not to damage the
mains cable (external)
Insert the wall plugs
necessary, use a hammer (see Fig. E).
Guide the power cable through the drill hole in
the light fixture provided for this purpose
1
and attach the light to the ceiling (see Fig. F–G).
Connect the three building wires in the light fix-
ture's terminal block
1
the colours.
Note: Be sure to correctly connect the individ-
ual leads on the mains cable (external)
wire, black or brown = symbol L, neutral wire,
blue = symbol N, earth wire, green-yellow=
symbol
Install the lights' plastic cover
match the cover's three notches to the corre-
sponding retaining bolts
press it from the bottom up. Turn the cover
clockwise (right, following the direction of the
arrow) to fix it. The adhesive label with the
arrow can now be removed.
11
Replace the fuse or switch on the circuit
breaker in the fuse box (I position).
Your LED ceiling light
12
now ready.
in the desired posi-
1
(see Fig. D).
6
(see Fig. E).
7
in the drilled holes. If
5
, as indicated by
8
: live
7
. To do this,
2
(see Fig. H) and
10
with Bluetooth speaker is

Installing the wall bracket

Install the wall bracket for the remote control
using the screws
25
shown in Figure I.

Inserting / replacing batteries

Note: The remote control requires two batteries type
AAA / LR03 (included).
Slide the battery case cover (reverse) down by
approx. 1 cm to open and then lift off the cover.
Insert two batteries of the included type
AAA / LR03 in the battery compartment. Please
note the correct polarity!
Slide back the cover to close the battery
compartment.
Your remote control is ready to use.

Operating the light by switch

The LED ceiling light
and off using the wall switch. Here the bright-
ness will always be 100 %. All other functions
are solely controlled via remote control.

Using the remote control

ATTENTION! The functions of the remote control
can only be used after switching the LED ceiling
light on with the wall switch.
12

Switching the light on / off

1. Switching the light on
Press the " " button (lighting)
LED ceiling light
12
tion of the signal.
2. Switching the light off
Press the " " button (lighting)
the LED ceiling light
reception of the signal.
Initial use
or adhesive pads as
27
may be switched on
12
, to switch the
13
on. A beep confirms recep-
, to switch
14
off. A beep confirms
12
GB/IE
26
17