Operating Instructions; Live Screen - RIDGID micro CA-330 Manual De Operación

3. Make sure the micro CA-330 Inspec tion
Camera has been properly inspect ed
before each use.
4. Install the correct accessories for the ap-
plication.

Operating Instructions

WARNING
Always wear eye protection to protect
your eyes against dirt and other foreign
objects.
Follow operating instructions to reduce
the risk of injury from electrical shock,
entanglement and other causes.
1. Make sure that the Inspection Camera
and work area have been properly set up
and that the work area is free of bystand -
ers and other distractions.
2. Press and hold the Power Button for two
seconds. The imager lights should come
ON, then a splash screen (Figure 11)
will appear. This screen tells you the de-
vice is booting up. Once the product is
fully powered up, the screen will automat-
ically switch to the live screen.
Figure 11 – Splash Screen

Live Screen

The live screen is where you will do most of
your work. A live image of what the camera
sees is displayed on the screen. You can
zoom, adjust LED brightness and take im-
ages or video from this screen.
The screen has a status bar at the top show-
ing the tool mode, zoom, SD™ card icon if in-
serted, available memory and speaker/mic
ON/OFF. The information bar at the bottom
shows the date and time if time stamp is ON.
micro CA-330 Inspection Camera
Figure 12 – Live Screen
When the Inspection Camera is turned ON, the
default mode is for capturing still images.
Pressing the menu button at any time will ac-
cess the menu. The menu will overlay on the
LIVE Screen. Use the right and left arrow
buttons to switch to the MODE category. Use
the up and down arrows
tween menu items and press select
sired.
Figure 13 – Screen Shot of Mode Selection
3. If the other inspection camera settings
(Time Stamp, Language, Date/Time, TV
Out, Update Firmware, Speaker/Micro -
phone, Auto Power OFF, Factory Reset)
need to be adjusted, see Menu Section.
4. Prepare the camera for inspection. The
camera cable may need to be pre-formed
or bent to properly inspect the area. Do not
try to form bends less than 5" (13 cm)
radius. This can damage cable. If inspect-
ing a dark space, turn the LEDs on before
inserting the camera or cable.
Do not use excessive force to insert or
withdraw the cable. This may result in
damage to the inspection camera or in-
spection area. Do not use the cable or im-
ager head to modify surroundings, clear
pathways or clogged areas, or as any-
thing other than an inspection device.
Status
Bar
Informa -
tion Bar
to navigate be-
as de-
9