Crivit Sports 1-LD3814 Manual De Instrucciones página 15

Wearing the chest belt
Adjust the chest belt so that it fits
snugly directly below the chest
muscles. Moisten the contact
areas with water or ECG gel
(ECG gel can be purchased at a
pharmacy). Ensure that the
contact areas constantly remain
in skin contact.
Position the chest belt as per the
following illustration.
Please ensure that the chest belt is
seated properly. When you have
exhaled completely the chest belt
should still have very slight
tension pressing it to your chest.
High voltage power lines, Trains
or moving vehicular traffic may
interfere with the heart rate
measurement. Please consider this
when planning your exercise
route.
Coded transmission
The chest belt's transmissions are digitally coded to prevent interference if you are
training with a training partner who is using an identical watch and chest belt.
When using the chest belt for the first time, a random channel is selected
automatically. The channel is briefly displayed at the top of the display upon
entering the heart rate display mode. The available channels are CH10, CH11,
CH12, CH13 and CH14.
The channel can be changed by briefly removing the battery from the chest best
and reinserting it. The chest belt will randomly select a channel and after approx. 1
minute the heart rate and the new channel will appear on the display of the watch.
Press MODE to select the mode of operation of the watch.
The order of the modes is as follows:
Time and basic settings
TIME ZEIT
Stop watch
CHRONO ST-UHR
Heart rate
HRM PULS
Each mode of operation may have several subfeatures.
The subfeatures can always be accessed by pressing SEL
Speed setting
When setting numerical values, press and hold SEL to use the speed setting
feature.
Time and basic settings
Press MODE to select the feature before proceeding.
TIME ZEIT
The subfeatures of the time mode can be accessed by pressing SEL.
Time and basic settings
TIME ZEIT
Alarm
ALARM ALARM
Timer
TIMER TIMER
All manuals and user guides at all-guides.com
contact area
 - 55 -
TEMPS HORA
CHRONO CRONO
FC PULSO
SEL.
SEL SEL
TEMPS HORA
TEMPS HORA
ALARM ALARMA
COMPTE TIMER
 - 57 -
Using the bicycle holder
The included bicycle holder can be used to attach the wrist watch to the handlebar
of a bicycle.
Press the bicycle holder onto the top of the handlebar. Handlebars with an
especially large diameter may require the use of additional force to snap on the
bicycle holder. The heart rate monitor can now be attached to the bicycle holder
in the same way that you would attach it to your wrist.
The maximum range of 70cm between the wrist watch and the chest belt should
not be exceeded.
Light
Briefly press LIGHT to temporarily activate the light.
Important notes on the operation of the wrist watch
3 different Modes of Operation.
The watch has
Press and hold SET for 3 seconds to access setting mode.
The display will show
HOLD HALTEN=
TO SET EINST.
and the 12 or 24 hour selection will blink on the display.
Press SEL to select a setting and confirm your setting by pressing SET. Set the
seconds, minutes, hours, year, month and day in the same way.
Now the basic settings will follow. First the year of the birthday setting will appear
BIRTHDAY GEB-TAG
Press SEL to set the year and press SET to confirm your setting. Set the month and
day in the same way.
Now the weight will appear
WEIGHT GEWICHT
Set the digits of your weight by pressing SEL and confirm each digit by pressing
SET.
Now the height display will appear
HEIGHT GROESSE
Set each digit of your height by pressing SEL and confirm each digit by pressing
SET.
Exit setting mode by pressing MODE.
Second time zone
Press and hold SEL for 3 seconds. The watch will switch to the second time zone
display and T2 will appear on the display. Setting the second time zone can be
accomplished in the same way as described in the previous paragraph.
Press and hold SEL for 3 seconds to return to normal time mode.
 - 56 -
MAINT= MANT=
REGLER AJUST
DATNAISS CUMPL-AN
POIDS PESO
TAILLE TAMANO
 - 58 -