Drive Medical RTL12032KDR Manual De Instrucciones página 2

assembly instructions
Weight Capacity: 400 lbs (181 Kg)
1. Remove contents from carton.
2. Lay both transfer bench seat sections upside down on
a flat surface.
3. Align the U-shaped bracket with the large seat board.
The "U" should be facing towards the legs marked with
"A". Slide the large seat board tube into the U-bracket
by depressing the push pins and inserting into the
receptacles. Push pins will pop out when secure.
Repeat for second U-bracket. (Figure 1)
figure 1
4. Align the short seat board with the U-bracket tubing.
Slide the short seat board tube into the U-bracket
by depressing the push pins and inserting into the
receptacles. Push pins will pop out when secure.
Repeat for second U-bracket. (Figure 2)
figure 2
5. Attach leg with the large suction cup (marked "A")
by depressing the push pin and inserting into the
receptacle with the matching "A". Repeat for second
leg. (Figure 3)
figure 3
6. Attach leg with small rubber tip (marked "B") by
depressing push pin and inserting into the receptacle
with matching "B". Repeat for second leg.
(Figure 4)
figure 4
7. To assemble backrest, insert support tube into backrest
support by depressing push pin and sliding into
backrest tube. Repeat for second support. (Figure 5)
figure 5