Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
IMPROPER USE OR FAILURE TO FOLLOW INSTRUCTIONS CAN RESULT IN
PRODUCT FAILURE OR INJURIES. FOR SAFE USE OF THIS PRODUCT YOU
MUST READ AND FOLLOW ALL INSTRUCTIONS BEFORE USING.
Assembly Instructions
• Loosen wing nuts and flip up handle
• Tighten wing nuts completely
General Operating Instructions
• Be sure gate control is in the closed position before filling hopper
• Determine appropriate setting for material being used by reading the suggested setting on the material's bag
AND/OR by referencing the application chart on your spreader's control panel (Charts provided are only
guidelines. Be sure to read the instructions on the bag/box of the material you're spreading to identify accurate
setting needed)
• Remove wing nut and slide indicator to desired setting. Tighten wing nut completely.
• To begin spreading, start walking (about 3mph pace) and push the gate control away from you to open gate
• To stop spreading simply pull the gate control into the closed position
Storage and Maintenance
• When finished spreading empty hopper of any remaining material
• Thoroughly wash spreader and allow to dry before storing
• To fold down handle:
- Loosen wing nuts and flip handle down
- Tighten wing nuts completely
Replacement Parts
Ref.#
Qty
1
1
2
1
3
2
*
1
*
1
*
1
*
1
* Not Shown
All manuals and user guides at all-guides.com
WARNING
Part No.
6-9003
6-9004
6-9005
6-9006
6-9007
6-9029
6-9028
2
3
Description
Wheel, Molded 8" (80008N)
Axle Cap Driver, Idler (80008N)
M6 x 10mm Hex Bolt
Wheel, 10" Solid Rubber (80028N)
Axle Cap Driver, Idler (80028N)
Auger Kit
Baffle Kit
Handle
Bolt
2
1
Wing
Nut
3
Publicidad
Tabla de contenido
