Operate The Prism Printer; Power On And Off The Prism Printer; Power On Or Off A Standalone Printer; Power On Or Off A Printer Connected To An Autoloader Or Autoprinter - Rimage PrismPlus! Guia Del Usuario

Operate the Prism Printer

This section provides information needed to operate your Prism printer.

Power On and Off the Prism Printer

Power On or Off a Standalone Printer

1. Press the power switch on the rear of the printer. The printer powers on and initializes.
2. Press the power switch again. The printer powers off.
Power On or Off a Printer Connected to an Autoloader or
AutoPrinter
Follow these steps if your Prism is connected to an autoloader or AutoPrinter:

Note: The power switch on the printer must be in 'on' position.
1. Power on the autoloader or AutoPrinter. The printer powers on and initializes.
2. Power off the autoloader or AutoPrinter. The printer powers off.

Place a Disc on the Printer Tray

1. Press the operator button to open the printer tray.
2. Place one disc on the rubber pad between the two clamping pins and the centering pin.
-
Important! Place the disc with the recording side facing down. The recording side has a raised stacking ring close to
the hub. If a disc is inserted with the stacking ring facing up, the print head could be damaged.

Notes:
•
If the disc is resting on the clamping pins, the printer tray will not close.
•
The print pad and plate vary between the standalone and the automated models. The automated models have a
hole through the center of the plate; the standalone model does not. All models have a centering pin.
3. Press the operator button. The printer tray closes.
110635_J
All manuals and user guides at all-guides.com
Operate the Prism Printer
Centering Pin
Clamping Pins
Power Switch
13