Battery Installation - TechLine Z-40 Manual De Instrucciones

Symbols:
Memory Zone1: Appears when the monitor is operated in memory zone 1
Memory Zone 2: Appears when the monitor is operated in memory zone 2
Weak Battery Mark: Appears when batteries should be replaced
Pulse Mark: Shows the pulse rate per minute
Memory Mark: Shows the number of stored measurements
Measurement Error: Exceeding measurement range. Measure again quietly. Wrap the
cuff correctly and keep wrist steady during measurement. If error keeps occurring, contact
the service center.
Air Circuit Abnormality: Measure again quietly. If error keeps occurring, contact the
service center.
Pressure Exceeding 300 mmHg: Switch the unit off and measure again quietly. If error
keeps occurring, contact the service center.
Data Error: Remove and reload the batteries. If error keeps occurring, contact the service
center.

Battery Installation

1. Place your thumb on the side of the battery cover. Pull the battery cover in the direction of
the cuff to open.
2. Install lower battery first in the bottom position with the battery ribbon underneath. Battery
Type: 2 Alkaline LR03 (AAA) size.
3. Replace the cover by placing the end tabs of the battery cover in the slots on the top of the
battery compartment. Click in the other to secure the battery cover.
Replace the batteries if:
1. The weak battery symbol appears in the display.
2. Nothing appears in the display when the power
All manuals and user guides at all-guides.com
is switched on.