Applying The Cuff; Correct Measuring Posture - TechLine Z-40 Manual De Instrucciones

As the supplied batteries are for test only, they may be discharged earlier than batteries you buy
in stores. Replace the batteries in pairs. Remove batteries when unit is not in use for extended
periods of time.
Note:
Battery is hazardous waste. Do not dispose it together with the household
garbage.

Applying the Cuff

1. Remove your watch, jewelry, etc. prior to attaching the wrist monitor.
2. Apply cuff to left wrist with palm facing up as fig. A.
3. Make sure the edge of the cuff is about 1 cm from the palm as fig. B
4. In order to insure accurate measurements, fasten the velcro strap securely around your
wrist so there is no extra space between the cuff and the wrist as fig. C. If the cuff is not
wrapped tight enough, the measurement values may be incorrect.
5. If your physician has diagnosed you with poor circulation on your left arm, carefully place the
cuff around your right wrist as shown in fig. D.

Correct Measuring Posture

1. Place your elbow on a table so that the cuff is at the same level as your heart as fig. A
Note:
Your heart is located slightly below your armpit a bit to the left of the middle of your chest.
Relax your entire body, especially the area between your elbow and fingers.
2. If the cuff is not at the same level as your heart or if you cannot keep your arm completely still
throughout the reading, use a soft object such as a folded towel to support your arm as fig. B.
Dot allow hard objects to come in contact with the wrist cuff.
3. Turn your palm upwards.
4. Sit upright in a chair, and take 5-6 deep breaths. Avoid leaning back while the measurement
is being taken as fig. C.
All manuals and user guides at all-guides.com