Recalling Values From Memory - TechLine Z-40 Manual De Instrucciones

4. When the measurement is completed, systolic, diastolic and pulse will be shown
simultaneously on the LCD screen. The measurement is then automatically stored
into the pre-designated memory zone.
This monitor will re-inflate automatically to approximately 220 mmHg if the system detects
that your body needs more pressure to measure your blood pressure.
Note:
1. This monitor automatically switches off approximately 1 minute after last key operation.
2. To interrupt the measurement, simply press any key. The cuff will deflate immediately after a
key is pressed.
3. During the measurement, do not talk or move your arm or hand muscles.
4. Measurement readings: The display will automatically show the systolic and diastolic pressure
in mmHg after each measurement and the pulse rate/min too.
Please see the example below:
Systolic
Rounding out number

Recalling Values from Memory

1. The Monitor has two Memory Zones (1 and 2). Each zone can store up to 50
measurements.
All manuals and user guides at all-guides.com
Diastolic
12.8
↓
Rounding out number
7.9 = 13 by 8
↓