Grundig GDKP 5460 B Manual Del Usuario página 13

5 Installation of appliance
• Depth of drilling holes must comply with the
length of bolts.
• The bolts and dowels provided are suitable for
brick walls. For other construction material (e.g.
drywall, plate, porous concrete), suitable fixing
dowels and nuts shall be used.
(Figure 7)
CAUTION: Before drilling, ensure
A
that there are no power, gas or wa-
ter pipes in the close proximity of the
drilling locations.
Draw a mid location line from the ceiling perpen-
dicular to the lower edge of the hood (Figure 7).
Fix the assembly scheme on the wall. For points A
and B, take the maximum dimensions of the hood
as reference, and drill points A and B you have
marked with a Ø6 mm drill bit, and tap Ø6 mm
plastic wall plugs. Install the chimney connection
plate to the wall with 2 pieces of 3.9x22 screws
(Figure 8).
To install the hood body, drill points C,D,E,F spec-
ified in the installation template with a Ø10 mm
drill bit and tap Ø10 mm plastic dowels to these
points (Figure 8).
Cooker Hood / User Manual
F
4x
Ø10m m
Install 2 pieces of 5.5x60 mounting screws to
points C and D with a clearance of 5 mm between
the screw head and the wall (Figure 8).
(Figure 8)
Install two pieces of hanging plates to the body
of the hood with M5x35 mounting screws
(Figure 8).
(Figure 9)
Hold the cooker hood by its body and place it on
the mounting screws on the wall and tighten the
screws (Figure 9).
Install M4 washers to the 5.5x60 suspension
screws. Secure the cooker hood with 5.5x60
screws to the wall through the mounting hole on
the interior of the appliance (Figure 9).
13 / EN