Operation - Amann Girrbach Therm DRS Modo De Empleo

A P P L I C A T I O N
7.4

Operation

▷ Switch the furnace on via the main switch.
E N
▷ Define the sintering program, if required (see
Chapter 6.2).
▷ Open the furnace door by pressing button
the display.
▷ Place firing aid with sintering objects on the sin-
tering base (see Chapter 7.3).
▷ Close the furnace door.
▷ Start the sintering program (see Chapter 6.3).
After the program has elapsed, the heating
cycle automatically switches off.
After the program has ended, the furnace door
can open automatically while still hot, depending
on the program type. An acoustic signal sounds. A
corresponding warning is indicated on the display.
P1 Zolid DRS - Dry
Fig. 24 Hot furnace warning
WARNING:
Danger of burning!
▷ To remove the sintered objects when the fur-
nace is hot, use tweezers from the delivery
scope or a suitable other tool.
44
950°C Caution hot! 00:00
on
Fig. 25 Using tweezers
▷ Do not remove sintered material until the fur-
nace temperature is at least reached 850 °C.
This temperature is indicated by a symbol in the
display.
P1 Zolid DRS - Dry
850°C
Fig. 26 Note: Remove sintered material
▷ Place still hot sintered material on the cooling
plate provided.
Caution hot! 00:00