Bunn My Café MCA Manual De Instrucciones página 15

TROUBLESHOOTING (Cont.)
SITUATION
(Continued)
The water shuts off and comes
back on again when brewing.
The Pod Holder will not come
out of the brewer.
Water is appearing on the
counter around the base of the
brewer.
Water leaks out around the
sprayhead.
All manuals and user guides at all-guides.com
EXPLANATION
again. This is normal and will take about 45
seconds to complete. Wait for the blue lights
to go out.
NOTE: Although the pulse brew process can
be used for coffee or tea, it is designed to
brew tea. Because the process of brewing
tea is different than coffee, the brewer works
differently when the TEA BREW BUTTON is
used. An "On-Off-On" cycle is used to steep the
tea and provide the maximum flavor extraction.
This is normal.
The pod in the POD HOLDER may have swelled
to a point where the holder does not slide out
easily.
Wait at least 10 minutes and then try
carefully removing the pod holder again.
CAUTION: Hot liquid may be present.
The WATER RESERVOIR has been removed
to be filled with water and was not seated
properly when it was replaced.
Remove the lid from the top of the brewer.
With firm, but not forceful pressure, press
down on both sides of the reservoir to
ensure that the seal in the bottom of the
reservoir seats properly. Replace the lid and
watch for additional water around the base
of the brewer. If a problem persists, contact
Customer Service. (Refer to page 18 for
customer assistance.)
Replace a damaged seal or tighten a loose
sprayhead.
Refer to "Assembling The Sprayhead/Seal"
& "Inspecting The Sprayhead/Seal" sections
for detailed information on how to resolve
sprayhead leaks.
CAUTION: Wait for hot liquid to cool.
1