Starting The Pump - Agilent Technologies Turbo-V 1000HT PCB Manual De Instrucciones

Starting the Pump

If the forepump and vent device are not operated by the controller,
close the vent valve and switch on the forepump.
With the FRONT panel operation selected, the REMOTE operation is inoperative;
NOTE
conversely, the CYCLE NUMBER and PUMP CURRENT pushbuttons are always
active, even when the operating mode selected is REMOTE.
S
Figure 32
Turbo-V 1000HT PCB Controller User Manual / 87-900-906-01 (F)
Press the START pushbutton (or use the remote start signal), and
the display shows:
O F T
[ . .
S T A R T
. . . . .
Technical Information
Use
O N
. . . ]
249/262
17