Torque Limiter - Makita HR2432 Manual De Instrucciones

To start the tool, simply pull the switch trigger. Tool speed
is increased by increasing pressure on the switch trigger.
Release the switch trigger to stop. For continuous
operation, pull the switch trigger and then push in the
lock button. To stop the tool from the locked position, pull
the switch trigger fully, then release it.
Reversing switch action
A
B
2
001293
This tool has a reversing switch to change the direction of
rotation. Move the reversing switch lever to the
(A side) for clockwise rotation or the
for counterclockwise rotation.
CAUTION:
Always check the direction of rotation before
•
operation.
Use the reversing switch only after the tool comes
•
to a complete stop. Changing the direction of
rotation before the tool stops may damage the tool.
When you operate the tool in counterclockwise
•
rotation, the switch trigger is pulled only halfway
and the tool
counterclockwise rotation, you cannot push in the
lock button.
Selecting the action mode
Rotation with hammering
3
003573
For drilling in concrete, masonry, etc., depress the lock
button and rotate the action mode changing knob to the
symbol. Use a tungsten-carbide tipped bit.
1. Switch trigger
2. Reversing switch
lever
1
position (B side)
runs at half speed.
1. Rotation with
1
hammering
2
2. Lock button
3. Action mode
changing knob
Rotation only
003575
For drilling in wood, metal or plastic materials, depress
the lock button and rotate the action mode changing
knob to the
Hammering only
position
003574
For chipping, scaling or demolition operations, depress
the lock button and rotate the action mode changing
knob to the
scaling chisel, etc.
CAUTION:
For
Do not rotate the action mode changing knob when
•
the tool is running under load. The tool will be
damaged.
To avoid rapid wear on the mode change
•
mechanism, be sure that the action mode changing
knob is always positively located in one of the three
action mode positions.

Torque limiter

The torque limiter will actuate when a certain torque level
is reached. The motor will disengage from the output
shaft. When this happens, the bit will stop turning.
CAUTION:
As soon as the torque limiter actuates, switch off
•
the tool immediately. This will help prevent
premature wear of the tool.
Hole saws cannot be used with this tool. They tend
•
to pinch or catch easily in the hole. This will cause
the torque limiter to actuate too frequently.
5
1
symbol. Use a twist drill bit or wood bit.
1
symbol. Use a bull point, cold chisel,
1. Rotation only
1. Hammering only