Rollei 58 Instrucciones página 83

machine, to create a variety of lighting effects . They are suitable for manual flash
and TTL flash .
2 . In these two modes, the output brightness is adjusted as in the M mode .
S1 mode: This mode is suitable for manual
flash environment . It will sense every flash of
the main flash and will trigger synchronously
flashes . Your master flash should be set in the
manual flash mode and should neither use
preflash TTL flash system, nor multiple flash
red-eye reduction function .
S2 mode: This mode is suitable for TTL flash
mode, also known as preflash cancel mode,
as this mode can ignore the preflash TTL and
synchronizes with the main flash . So you can
support the master flash in TTL mode .
Note: If the SLAVE light does't sync flash with the MASTER flash light in S1/S2
mode, pleaes set the optcial mode of SLAVE light and power output correctly .
Please avoid the following situations mentioned below:
• Avoid MASTER light to use red eye reduction function
• Avoid MASTER light to use instruction mode (Nikon) or wireless mode (Canon)
• Avoid MASTER light to use ST-E2 and the vice factory master flash as a flash
controller .
Note: If your camera does not have a built-in flash (such as Canon 5D, 5D II, 5D III),
it is unable to use the SLAVE c/SLAVE n S1/S2 or Slave mode separately . Because
the SLAVE c/SLAVE n or S1/S2 mode require to use the Master light exposure . If you
need to use this feature, you need to purchase the original Canon flash or ST-E2 as
a flash controller .
83