Thank you for purchasing a vitapur
enclosed operating instructions carefully and retain this booklet for future reference.
We have carefully engineered your vitapur
trouble free operation.
IMPORTANT SAFEGUARDS
Warning: This water dispenser is designed for indoor applications only. DO NOT use outdoors.
Important Note: Your Vitapur® water dispenser is designed with a special "safety" feature (float switch mechanism) that
controls activation / operation of the "Kettle Feature" hot water tank heating system. If no water is present and / or low
water levels are detected inside the internal water reservoir, the "yellow" LED light adjacent to the empty water bottle icon
on the control panel starts flashing to signify activation / operation of the "Kettle Feature" hot water heating system is not
possible. To eliminate / cancel the "yellow" flashing light condition, you must add water into the dispenser at which time
the "yellow" light will automatically switch off. Likewise, if the hot water heating system is operational and water is being
drawn simultaneously causing internal water levels to drop below the established minimum level set point, hot water tank
operation is automatically suspended. To reactivate the hot water heating system, you must replenish your water supply.
Note: Operation of the cold water system is not affected by this safety feature.
• Never turn the dispenser upside down or tilt more than 45 degrees. If the unit has been resting on its' side for an
extended period of time, place the water dispenser in the upright position for approximately 12 hours before turning
it on.
• For use with 3 or 5 gallon (12 or 19 liter) water bottles and most water filtration systems (not included).
• Never use this dispenser with water that is unsafe to drink or is from an unknown source.
• Never use any other liquid in the dispenser other than known and microbiologically safe bottled water.
• Never allow children to dispense hot water without proper and direct supervision.
• This water dispenser is equipped with a grounded power cord plug for your safety.
• Keep your water dispenser in a dry place away from direct sunlight.
• Never put anything flammable close to the dispenser.
• Leave a minimum of 2" (5 cm) around the back and sides of the dispenser for proper ventilation.
• Always install your water dispenser on a level counter.
• Always unplug the water dispenser before servicing or cleaning.
• Regular cleaning of your water dispenser is required for your warranty. Please follow the cleaning instructions
outlined in this manual and clean the dispenser every 4 months.
To avoid water overflow when cleaning your dispenser, always remove
the bottle support collar before pouring water or cleaning solution
into the reservoir.
All manuals and user guides at all-guides.com
Water Dispenser. Please read the
®
Water Dispenser to give you years of enjoyment and
®
1