Cleaning And Maintenance - vitapur VWD2636W-3 Manual De Uso Y Cuidado

Child Resistant Safety Switch
To prevent hot water from accidentally harming a child, the hot water dispenser
button has a safety switch on it. Slide the switch to the left and push the button
down to dispense hot water.
DANGER: The hot water is heated to approximately 201˚F / 91˚C.
Temperatures above 125˚F / 52˚C can cause severe burns from scalding. DO
NOT AllOW CHIlDREN TO USE THE HOT WATER DISPENSING BUTTON
WITHOUT PROPER AND DIRECT SUPERvISION.

ClEANING AND MAINTENANCE

Like most appliances, your water dispenser requires periodic maintenance for maximum efficiency and performance and
must be cleaned on a regular basis (i.e. every 4 months). To maintain a hygienic environment within your water dispenser
and prevent potential formation (growth) of bacteria, we strongly recommend regular cleaning. A cleaning kit is available
through our Customer Service Department at 1-866-253-0447 or can be ordered on line at www.greenwayhp.com.
Cleaning Your Water Dispenser
IMPORTANT: Make sure you unplug the dispenser before performing any of the following cleaning procedures.
Cleaning the Outside of the Water Dispenser
The outside of the dispenser can be wiped clean with a mild soap and water mixture. Never use harsh chemicals or
abrasive cleaners. Rinse thoroughly with clean water and then dry surfaces.
Cleaning the Drip Tray
To remove, take the grill off the tray and firmly lift the tray up, dislodging it from the
guides. Drain and clean.
The drip tray should be emptied and cleaned regularly to remove spotting and any
mineral deposits. Clean with a vitapur
soap and water mixture. For tough deposits, add vinegar and let it soak until the
deposits come loose. Then wash, rinse and dry thoroughly (not dishwasher safe).
To replace, put the grill back on the tray and slide the tray onto the guides.
Draining the Reservoirs
Drain the reservoirs before and after cleaning, when going on long vacations or if not
using the dispenser for long periods of time.
IMPORTANT! Unplug the dispenser before performing this procedure. Dispense
hot water until temperature drops to a safe level to avoid the
risk of scalding.
1. Remove the water bottle.
2. Press/hold all dispensing buttons until water stops flowing from the spigot.
3. Place the unit over the sink and drain both internal reservoirs by removing the
spring clamps and caps from both drain outlets located on the bottom of the unit.
4. When the water completely stops flowing, replace the drain caps and spring clamps.
IMPORTANT: Drain the water into a container and/or sink, not the drip tray.
All manuals and user guides at all-guides.com
® water dispenser cleaning solution or a mild
5
Child Resistant
Safety Switch
bottom of dispenser
Hot Cool