Intended Use; General Safety Instructions - brennenstuhl BSV 3 Instrucciones De Uso

BSV 3, BSV 4, BKV 2/4

INTENDED USE

The products are used as mobile power distributors indoors and outdoors.
The products are designed for professional use.
Any use which is not specified as intended use will be considered as misuse.
The manufacturer will not assume any liability for damages resulting from misuse.
The user bears the entire risk.
Unauthorised modifications and conversions will void the CE conformity and with it
any warranty claims. Modifications may cause hazards for life and limb as well as
damage to the distribution box or connected loads.
Factory labels on the distribution box must not be removed, changed or made illegible.
PROTECTION AGAINST FOREIGN OBJECTS AND WEATHER
The protection type of this distribution box is IP 44 according to DIN EN 60529
(VDE 0470-1) provided that the correct operating position is observed.
See "Commissioning" section.
IP 44 means:
- IP 4X: Protected against solid foreign objects with a diameter of more than
1.0 mm, e. g. wire.
- IP X4: Protection against water splashing from any direction.

GENERAL SAFETY INSTRUCTIONS

Qualified electrician
Mounting, disassembly, installation, commissioning and servicing of the device
may only be performed by a qualified electrician. The qualified electrician must
meet and observe the following requirements:
- Intended use of the device.
- Compliance with the installation and operating instructions.
- Knowledge and application of the relevant electrotechnical provisions (e. g. DIN
VDE 0100 Part 600, DIN VDE 0100 Part 410) as well as the country-specific provisions
regarding the construction of electrotechnical systems.
- Knowledge and application of the general and specific safety and accident
prevention regulations.
- Ability to recognise risks and prevent possible hazards.
- Handover of the installation and operating instruction to the operator/user of the device.
Operation/Use
- Safe use is only ensured if these instructions are fully observed.
- Read these instructions thoroughly prior to installation, commissioning or operation.
- The distribution box is to be properly installed, maintained and commissioned by
qualified experts in compliance with the relevant laws, regulations and standards.
- Never cover the distribution box to prevent trapped heat and the resulting fire hazard.
- Keep easily flammable and explosive substances away from the distribution box.
- Protect the cables
- by pulling at the plug and not at the cable to disconnect the device,
- by preventing mechanical damage to the cables,
- by keeping them away from intense heat.
027621 BA_Baustromverteiler 0533497.indd 13 027621 BA_Baustromverteiler 0533497.indd 13
Operating instructions
13
06.07.21 14:02 06.07.21 14:02