Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 55
Operating instructions

STORAGE AND DISPOSAL

Storing the device
For proper storage and to ensure the failure-free operation of the device later,
observe the following instructions.
Clean the device prior to storage. (see "Cleaning and care" section).
Store the device in its original packaging or in a suitable cardboard box.
Store the device in a dry and temperature-controlled room at a storage temperature
between 0° C and +35 °C.
Dispose of the device
Dispose of electric appliances in an environmentally friendly manner!
Electric appliances must not be disposed of in household waste. The European
Directive 2012/19/EU on Waste Electrical and Electronic Equipment rules that
used electric appliances should be collected separately and recycled in an environmen-
tally friendly manner. For possibilities of disposal of the used appliance, please contact
your local or municipal administration.
FAULTS AND RECTIFICATION
DANGER
The device contains parts under life-threateningly
high electrical voltage.
Have all repair work performed by specialists.
Never operate the power distributor if it is defective.
Electrical loads which are connected to the power distributor may start automati-
cally when triggered protective equipment is re-activated and cause injuries.
Only activate protective equipment when you have switched off all connected
loads or disconnected them from the power distributor.
If one of the connected loads is no longer supplied with voltage, proceed as follows:
1. Pull the corresponding plug out of the power distributor.
2. Visually inspect the power distributor and the connected loads for defects.
- If there is a defect in one of the devices, call in an electrician. Troubleshooting is
hereby completed.
- If this is not the case, continue with step 3.
3. Check whether the responsible fuse element or the RCD has tripped.
If this is the case, continue with step 4, otherwise inform a qualified electrician.
Troubleshooting is hereby completed.
4. Switch on the fuse element or the RCD.
5. If the fuse elements trip again, the fault is in the power distributor.
Then continue with step 6.
- If the fuse elements do not trip, continue with step 7.
6. Take the power distributor out of operation and immediately notify a qualified
electrician or the manufacturer's service department.
Troubleshooting is hereby completed.
7. Re-plug load. If the fuse is triggered again, the load or its supply cable is faulty.
8. Inform a qualified electrician. Troubleshooting is hereby completed.
18
027621 BA_Baustromverteiler 0533497.indd 18
027621 BA_Baustromverteiler 0533497.indd 18
BSV 3, BSV 4, BKV 2/4
06.07.21 14:02
06.07.21 14:02

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Bsv 4Bkv 2/4

Tabla de contenido