Commissioning; Temperature Settings - Transtherm Caves Mas 1T Modo De Empleo

Commissioning

- Once you have waited 48 hours, connect your cabinet to the mains,
h aving ch e cked that there is power to the socket (ch e ck fuses and their amperage,
the state of the trip, and if necessary try out another electrical appliance to
verify the supply).
- Once connected to the mains, make sure that the Off/On switch, on the right
of your cabinet's control panel, is set at "On" (I).
- As soon as your wine cabinet is plugged in, as long as the switch is set at
"On" (see diagram above), and the ambient temperature is higher than the
temperature you require, the green operating indicator for the cold circuit
comes on (unless this is a 1 temperature model, and is placed in an area that
has a temperature close to 12°C). The thermometer starts up and shows the
temperature.
In the event of malfunction, turn to page 17 & 18
Hygrometry for 1 temperature cabinets
(References MA1XP, MA1XP, ER1XG for Asia and Australia only)
Installing Pozzolana (lava) bricks:
- Remove the small rack from the bottom of the cabinet
- Open the 4 bubble wrap packets and remove the bricks
- Lock them together using the dowels to make 1 large rectangle and place this
directly on the floor of the unit
- Dampen the 4 Pozzolana bricks with 2 or 3 glasses of water.
- Replace the small rack which will now sit on top of the groove.
All manuals and user guides at all-guides.com
.
P8
Temperature settings for 1 temperature models
The temperat u re control(s) and setting(s) are adjusted from your wine cab i n e t 's
settings panel, as shown below:
Temperature setting Hot circuit operating indi-
button cator (red)
Model Temperature display
If the loading arra n gement or location of your cabinet justifies it, you can adjust
the temperat u re setting up or down. To set the temperat u re of your 1 temperat u re
c ab i n e t : t u rn the temperat u re setting button until the mark mat ches up with the
t e m p e rat u re you re q u i re inside your cab i n e t .
Recommended temperature range: 10° to 14°C.
Te m p e rat u re settings for 3 temperat u re models
The temperat u re control(s) and setting(s) are adjusted from your wine cab i n e t 's
settings panel, as shown below:
Temperature display for room
temperature compartment Temperature display for maturing
compartment
Model Hot thermostat
setting button
room temperature
Cold therm o s t at
On/Off switch
setting bu t t o n
- You set your wine cabinet's temperatures using the hot and cold thermostat
adjustment buttons
- The table below gives the standard settings enabling you to obtain the right
t e m p e rat u re for pre s e rving your wines.
Model
COTTAGE
CASTEL
On/Off
switch
Cold circuit operating indi- Test
cator (green) button
Hot circuit operating
indicator (red) On/Off
switch
Cold circuit ope- Test
rating indicator Button
(green)
10 12
9 11
P9