Important Wine Information; Operating Anomalies - Transtherm Caves Mas 1T Modo De Empleo

Important wine information

Your TRANSTHERM cabinet has been designed to guarantee the optimum
conditions for storing and/or serving your wine
Wine is a highly complex product, requiring long and gentle development and
needs specific conditions in which to reach its full potential.
All wine is stored at the same temperature, only the temperatures for serving
and wine tasting can va ry depending on the type of wine (see the table on page 14)
This being the case and just like the natural caves used by wine producers, it
is not the exact temperature that is important, but its constancy. In other words,
as long as the temperature of your cabinet is between 10 and 14° C, your wine
will be stored in perfect conditions if the temperature is not subject to any
significant fluctuation
However, it is advisable to be especially careful concerning the values shown
on your wine cabinet's hy gro m e t e r, wh i ch , due to its location in the wine cellar
will always have tendency to display a lower humidity level.
IRRESPECTIVE OF THE CAU S E , IF YOU NOTICE EITHER
A B N O R M A L T E M P E R ATURE OR HUMIDITY LEVELS INSIDE
YOUR CABINET, BE REASSURED THAT ONLY LONG EXPOSURE
TO THESE ABNORMAL CONDITIONS CAN HA VE A DETRIMENTA L
EFFECT ON YOUR WINES.
All manuals and user guides at all-guides.com
P16

Operating anomalies

When starting up
The compressor will not operate at the temperature required, even though
the required temperature is less than the ambient temperature:
1- E n s u re that there is power to the electrical supply plug by connecting another
electrical appliance to it, as well as checking that the On/Off switch is in
position (1).
2- Press on the TEST button and check that the 2 indicator lights (green and
red) light up.
3- Turn the closed cold adjustment button (or the only temperature adjuster for
1 temperature models) in an anticlockwise direction right up to the stop, and
check that the green indicator light lights up.
4- If after carrying out steps 2 and 3 you still cannot get the compressor to start
up corre c t ly, contact your re t a i l e r.
The compressor will not turn off:
1- Place your hand on the condenser (metal grill located along the exterior wall
behind your cabinet). If the condenser is cold, get in touch with your re t a i l e r.
2- If the condenser is hot, turn the cold adjuster to its highest level, and check
that the cold circuit light goes out, if the compressor does not stop, get in
touch with your retailer.
In operation
The LCD display shows lower temperat u re(s) than re q u i re d :
1-Check the recommended temperature adjustment (see pages 9 to 13 in this
manual).
2-Check that the red, hot circuit indicator light is lit up.
3-Press on the TEST button and check that the 2 indicator lights (green and
red) located to the right of the panel are lit up. If either of steps 2 and 3 are not
correct, contact your retailer.
The LCD display shows higher temperat u re(s) than re q u i re d :
1-Check the recommended temperature adjustment (see pages 9 to 13 in this
manual).
2-Check that the green, cold circuit indicator light is lit up.
3-Press on the TEST button and check that the 2 indicator lights (green and
red) located to the right of the panel are lit up. If either of steps 2 and 3 are not
correct, contact your retailer.
THE USE OF GLASS DOORS HAS AN EFFECT ON PERFORMANCE
P17