Kohler 1083258 Manual De Instrucciones página 2

Spray Face
Remove the Spray Membrane
Pivot the spray face and use a 5/16" hex wrench to turn the screws
clockwise to disengage.
Repeat for all three screws.
Remove the spray face.
Carefully lift the spray membrane from the sprayhead. Use care to not
damage the spray membrane as it tears easily.
If you are only replacing the spray membrane, proceed to "Replace the
Spray Membrane" section, otherwise continue to "Remove the
Sprayhead" section.
Remove the Sprayhead
Insert a 1/4" hex wrench through the center of the sprayhead into the
ball joint.
Turn the ball joint clockwise, while holding the sprayhead stationary, to
remove the sprayhead and the clamp.
Remove the O-ring from the ball joint.
1083256-9-A
Membrane
Sprayhead
O-Ring
2
Sprayhead
Clamp
Kohler Co.