Saddle Stitcher Section; Hole Punch Section (Optional) - Kyocera DF-75 Guía De Instrucciones

Tabla de contenido

Publicidad

Saddle stitcher section

Item
Stacking system
Stitching system
Paper sizes
Number of sheets
Paper mass
Stacking capacity
Specifications for stapling
Specifications for foiding
Note 1: Special papers, postcard, and transparency film are not acceptable.

Hole Punch section (Optional)

Item
Type
Paper receiving reference
Paper sizes
Paper mass
Number of holes
Hole diameter
Punch waste capacity
44
Saddle stitcher section tray, fixed
Center stapling, folded into two
A3, B4, A4R, 11 × 17", and 8-1/2 × 11"
Without stitching: 1 sheet
With stitching: 2 to 10 sheets
64 g/m
2
to 128 g/m
2
[copier] (Note 1)
6 to 10 sheet sets: 10, 5 sheet or less sets: 20
Stapling location
Staple capacity
Staple detection
Manual staplimg
Folding system
Folding mode
Folding location
Serial processing
Center
A3, A4, B4, B5, 11 × 17", 8-1/2 × 14", and 11 × 8-1/2"
2
64 to 205 g/m
[copier]
The one of the following three patterns is available dependent on destinations:
1 2 holes
2 2 and 3 holes
3 4 holes
ø6.5 or ø8.0 mm depend on destinations
[copier]
1 2 holes
: 3,000 sheets (64 g/m
2 2 and 3 holes : 1,500 sheets (75 g/m
3 4 holes
: 1,500 sheets (80 g/m
[printer]
3,000 sheets (80 g/m
2
continuous two hole punching) with waste full sensor
Description
60 to 80 g/m
Two locations (even distance from the center, fixed distance)
5,000 staples
Provided
Not provided
Roller pressure folding
Folded into two
Center of paper
Description
2
60 to 200 g/m
[printer]
2
) with waste full sensor
2
) with waste full sensor
2
) with waste full sensor
2
[printer] (Note 1)

Publicidad

Tabla de contenido
loading

Tabla de contenido