Descargar Imprimir esta página

Menu Navigation; Auto Mode - HQ-Power VDPLOP3601RGB Manual Del Usuario

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

• Use an appropriate safety cable to fix the device (e.g. VDLSC7 or VDLSC8).
• Familiarise yourself with the functions of the device before actually using it. Do not allow operation
by unqualified people. Any damage that may occur will most probably be due to unprofessional
use of the device.
• Use the original packaging if the device is to be transported.
• All modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns,
electroshocks, lamp explosion, crash, etc. Using the device in an unauthorised way will void the
warranty.
4.
Features
• for in-and outdoor stage lighting
• perfect RGB colour mixing
• master/slave mode or DMX controlled
• stand-alone mode via pre-programmed effects
• powerful strobe function
5.
Installation
a) Fixture
• Hang the light into a suitable place in the desired angle.
• Insert the power-cord into the right power supply (240VAC/50Hz).
• Switch of the power if you are not using the VDPLOP3601 for a longer time.
b) Mounting the Device
• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable
norms.
• The construction to which the device is attached should be able to support 10 times the weight of
the device for one hour without deformation.
• The installation must always be secured with a secondary attachment e.g. a safety cable.
• Never stand directly below the device when it is being mounted, removed or serviced. Have a
qualified technician check the device once a year and once before you bring it into service.
• Install the device in a location with few passers-by and inaccessible to unauthorised persons.
• Overhead mounting requires extensive experience: calculating workload limits, determining the
installation material to be used... Have the material and the device itself checked regularly. Do not
attempt to install the device yourself if you lack these qualifications as improper installation may
result in serious injuries.
• Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
• Make sure there is no flammable material within a 50cm radius of the device.
• Have a qualified electrician carry out the electrical connection.
• Connect the device to the mains with the power plug. Don't connect it to a dimming pack.
• The installation has to be approved by an expert before the device is taken into service.
6.

Menu navigation

Manual mode

Auto mode

06/01/2009
VDPLOP3601RGB
1
red dimmer
2
green dimmer
3
blue dimmer
1
flash
2
automatic fade in and out
3
auto change 7 colours
4
chase lights
5
chase lights speed
3
© 2008 Velleman Components nv

Publicidad

loading