Control Panel; Reset Menu - Beretta MYNUTE X R Instrucciones De Instalacion Y Uso

MYNUTE X R
3.18

Control panel

A
B
LED
Light signal indicating the operating status of the boiler. Can be red or green (see specific paragraph).
A
It is normally used to raise the domestic hot water temperature, when the arrow
B
It is normally used to lower the domestic hot water temperature, when the arrow
C
It is normally used to raise the central heating water temperature, when the arrow
D
It is normally used to lower the heating water temperature, when the arrow
C+D
When heating programming timing is enabled, it allows you to pass from the automatic program to the manual one
A+C
Access to the menu for setting the clock (see paragraph "4.2 Programming the boiler")
B+D
Access to the programming timer menu (see paragraph "4.3 Time band scheduling function (room thermostat)"
1
Used to change the operating status of the boiler (OFF, SUMMER and WINTER)
2
Used to reset the alarm status or to interrupt the vent cycle
3
Used to access the INFO and SETTINGS menus. When the icon
the value set during the programming of a technical parameter
1+3
Lock and unlock keys
2+3
When the boiler is set to OFF it is used to start the combustion analysis function (CO)
The DHW function, on the display, is shown only in B and C cases.
10
+
RESET
1 2
Enter
LED
+
MENU
3
is highlighted it has, however, the confirm function
is highlighted it has the back/cancel function
is highlighted you can move within the settings menu
is highlighted you can move within the settings menu
is shown on the display, the key has the ENTER function and is used to confirm
C
D