Publicidad
Idiomas disponibles
Idiomas disponibles
Air Regulator
Inner Screw
Figure B
Adjust speed by turning inner screw clockwise or counter-clockwise with a flat tip screwdriver until desired air flow
is achieved.
Figure D
ALWAYS disconnect air supply before changing saw blades! Loosen blade set screw by turning counter-clockwise
with the included allen wrench.
Figure E
Set Screw
Fully insert new blade into saw. Tighten set screw by turning clockwise. ALWAYS make sure the set screw is tight
on BOTH sides.
Figure C
Set Screw
16) Do not install the tool unless an easily
accessible and easily operable on/off valve
is incorporated in the air supply.
17) Take care that the tool exhaust air does not
cause a problem or blow on another person.
18) Never lay a tool down unless the working
attachment has stopped moving.
19) Use a 24 tooth saw blade for cutting wood and
a 32 tooth saw blade for cutting metal. Always
use a blade appropriate for the material
being cut.
20) Always saw away from your body.
Safety Rules For Pneumatic Tools
1)
Inspect the air hose for cracks or other
problems. Replace the hose if worn.
2)
Never point an air hose at another person.
3)
Disconnect the tool when not in use, or before
performing service or changing accessories.
4)
Use proper hoses and fittings. Never use
quick-change couplings attached to the tool.
Instead, add a hose and coupling between the
tool and the air supply.
Figure A
The recommended hook-up is shown in figure A.
Pneumatic tools operate on a wide range of air
pressures. For maximum efficiency and longer tool
life, the pressure of the air supplied to these tools
should not exceed the rated PSI at the tool when
the tool is running. Using a higher than rated
pressure will cause faster wear and drastically
shorten the tool's life. A higher air pressure can
also cause an unsafe condition.
The inside diameter of the hose should be
increased to compensate for unusually long air
hoses (over 25 feet). Minimum hose diameter
should be 3/8" I.D. and fittings should have the
same inside dimensions.
The use of air line lubricators and air line filters is
recommended to prevent water in the line that can
damage the tool. Drain the air tank daily. Clean the
air inlet filter screen on at least a weekly schedule
to remove accumulated dirt or other matter that
can restrict air flow.
The tool's air inlet used for connecting an air
supply has standard 1/4" NPT American thread.
Publicidad
