Bahco TASMB Serie Traducción De Las Instrucciones Originales página 6

TASMB AND TAWMB SERIES
USER INSTRUCTIONS
SLIM & STD
FIGURE 1
BATTERY
CONDITION
WIRELESS LINK
CONDITION
USB DATA STORAGE
CONNECTOR ALERT
SCR
FIGURE 1
CONDITION
LIGHTS
WIRELESS LINK
CONDITION
DATA STORAGE
ALERT
TOOL POWER ON SEQUENCE
Note: Do not turn on tool while torque is applied, otherwise torque zero offset will be incorrect
and tool will indicate a torque reading when torque is released. If this occurs, re-zero tool by
momentarily pressing POWER button while tool is on a stable surface with no torque applied.
1. Turn On Tool.
While holding tool still, press POWER button. BAHCO logo will be displayed followed by torque and
angle re-zeroing screens (if angle mode has been previously selected). If real-time-clock has not been
and time). After entering date and time or if time has been previously set, target TORQUE or ANGLE
screen will now be displayed (depending on previous measurement mode selected).
Note: By simultaneously pressing the ENTER and UNITS U buttons, the keypad can be locked
to prevent inadvertent button presses while griping the screwdriver body. The Lock Icon is
displayed when the keypad is locked. To unlock the keypad, press the ENTER – UNITS U –
ENTER buttons in sequence (on screwdrivers (SCR) only).
Note: If the keypad was locked when powered down, on power up, the keypad will remain
locked and will require the keypad unlock button sequence of ENTER – UNITS U – ENTER to
become functional again (on screwdrivers (SCR) only).
Toggle between target TORQUE and ANGLE screens by repeatedly pressing ENTER button.
MODE
LIGHTS COUNT RE- ZERO BUTTON
LIGHTS
BATTERY
RE- ZERO BUTTON
MODE
COUNT
LIGHTS ENTRY BUTTON
INCREMENT MODE SELECT AND
BUTTON MENU ENTRY BUTTON
DECREMENT LCD BACKLIGHT
ENTRY BUTTON BUTTON
RECALL BUTTON
INCREMENT MODE SELECT AND
BUTTON MENU ENTRY BUTTON
DECREMENT LCD BACKLIGHT
BUTTON
RECALL BUTTON
Yellow:
Green:
AUDIBLE
ALERT
Red:
Yellow:
AUDIBLE
ALERT
Green:
Red: