Care And Maintenance - Sartorius YBT01 Instrucciones De Funcionamiento

Care and Maintenance

Service
Regular servicing by a Sartorius techni-
cian will ensure continuous correct
functioning of your wireless interface.
Sartorius offers service contracts with
regular maintenance intervals ranging
from 1 month to 2 years. The mainte-
nance interval depends on operating
conditions and tolerance requirements.
Repairs
!
Disconnect defective equipment from
power immediately. Repair work must
be performed by authorized Sartorius
service technicians using original spare
parts. Repairs performed by untrained
persons may result in considerable
hazards for the user. If the equipment
is still under warranty, send the entire
indicator to the factory for repairs.
Safety Inspection
Safe operation of the equipment is no
longer ensured when:
– there is visible damage to the device or
cable,
– the device no longer functions properly,
– the device has been stored for a rela-
tively long period under unfavorable
conditions (e.g., excessive moisture), or
– the equipment has been subjected to
rough handling during shipment.
If there is any indication that safe
operation of the device is no longer
warranted:
§ disconnect the equipment from power
immediately.
$ Lock the device in a secure place to
ensure that it cannot be used for the
time being, and
$ notify your nearest Sartorius Service
Center or the International Technical
Support Unit based in Goettingen, Ger-
many.
Cleaning
!
Handle the YBT01 and YDO01C-
BT/Option B2 wireless interfaces with
care.
!
Make sure no liquid enters the equip-
ment housing.
!
Do not use aggressive cleaning agents
(solvents or similar agents).
§ The accessible parts (antenna, adapter,
housing) can be cleaned by wiping with
a cloth slightly moistened with a mild
detergent.
!Using jets of water or compressed air
to clean the wireless interfaces is not
permitted.
Cleaning Stainless Steel Surfaces
Clean all stainless steel parts regularly.
Wipe down stainless steel parts gently
(e.g., the YBT01 housing) using a damp
cloth or sponge. You can use any
household cleaning agent that is suit-
able for use on stainless steel. Then
wipe the equipment thoroughly to
remove all residues. Afterwards, allow
the equipment to dry. If desired, you
can apply oil to the cleaned surfaces as
additional protection.
Note:
Do not apply detergents or cleaning
agents to ID labels or printed adhesive
tags!
Corrosive Environment
$ Remove all traces of corrosive sub-
stances on a regular basis.
35