Troubleshooting - Grizzly Tools GHS 2842 B Traducción Del Manual De Instrucciones Original

GB
testing procedure and may be used to
compare one power tool to another.
The stated vibration emission value may
also be used for a preliminary exposure
assessment.
Warning: The vibration emission
value may differ during actual use
of the power tool from the stated
value depending on the manner in

Troubleshooting

Problem
Motor not run-
ning or cuts out
during operation
Garden waste
is not drawn in
Shredding
material comes
out in chains
88
Possible cause
Collection box incor-
rectly attached
Overload protection
No mains power
supply
Safety switch is not
properly in place on
the collector box
Cylinder running in
reverse
Shredding material is too
soft
cylinder is jammed
Pressure plate is incor-
rectly adjusted
which the power tool is used.
Safety precautions aimed at pro-
tecting the user should be based
on estimated exposure under
actual usage conditions (all parts
of the operating cycle are to be
considered, including, for example,
times during which the power tool is
turned off and times when the tool
is turned on but is running idle).
Remedy
Push the collection box
home to its correct posi-
tion, and place the safety
switch on the box to the
ON position.
To switch back on, start by turning the
operating mode selection switch (
to the "OFF" position.
Press the reset switch (
Switch the device back on.
Check the socket, cable, lead and
plug for damage, and if necessary,
have any damage repaired by
qualified repair personnel.
Move the safety switch
into the ON position (see
section on emptying the
collector box)
Change rotational direction using
the switch
Insert wood or shred dried branches
Free up the jam
(See section on working methods)
Readjust the pressure plate (See
section on working methods)
9)
A
7).
A