T'nB SPCAMHD3 Modo De Empleo página 18

Specifications
LCD Screen 1.5"
Lens f/2.4mm Glass hemispherical lens 4 elements / Wide
angle 120°
Languages English, French, Spanish, Portuguese
Video Resolutions 1080P (1440 x 1080) 30 fps / 720P (1280 x 720)
30 fps / WVGA (848 x 480) 30 fps / VGA (640 x
480) 30 fps
Video Format MOV
Video compression format H.264 codec
Resolution of Photos 3 / 2 / 1MP
Memory Micro SD Class 10 up to 32 GB (not included)
Photo modes Trigger : Single shot / Burst
Frame frequency 50Hz / 60Hz
USB interface USB2.0
Power supply 3.7 V
Battery capacity 750 mAH
Recording time 720p / about 1hour and 30 minutes
Charging time About 1hour
Operating System Windows XP/Vista/Win7/Win8/Win10/Mac
Dimension of the camera 5.9 x 4.1 x 2.1 cm
Note : the specifications are subject to change as part of product improvement.
34
Notice to users:
The device delivers exceptional images
and videos. Therefore, only the micro
SD cards of minimum class 10 are
accepted by the device
Battery care and storage
The camera contains delicate parts,
especially the battery. It is not advisable
to drop, dismantle, open, crush, bend,
deform, pierce, expose to micro waves,
burn or repaint the camera, or to insert
things in the battery opening. Do not
use the camera or the battery if they
are damaged, for example if they are
cracked, punctured or water damaged.
If you dismantle or puncture the battery,
it may explode or catch fire. Do not
store your camera and battery in
excessive heat or cold. Very high or very
low temperature can reduce the battery
life or prevent proper functioning. Avoid
sudden changes in temperature or
humidity as condensation may occur
inside or outside the camera.
Battery disposal: The lithium-ion batte-
ries contain recyclable materials and
are considered recyclable. Find out
about the local laws and the recycling
centres in your locality. Before throwing
the lithium-ion batteries, cover the
terminal parts with sticky tape or with a
packaging foil to isolate and prevent the
terminals from coming into contact with
other metallic objects so that they do
not catch fire while transporting.
Prevention of damage due to the water
in your camera
The rubber seal that covers the inside of
the housing forms a waterproof barrier
that protects your sport camera in wet
conditions and under the water. Make
sure that the rubber seal remains clean.
A single hair or a grain of sand can
cause a leak. After each use in the salt
water, you must rinse the outside of the
housing with some fresh water and dry
it. Otherwise, the pivot may rust and the
salt accumulates in the seal, which can
cause some failures. To clean the seal,
rinse it in the fresh water and shake it
dry (wiping with a cloth may leave fluff
and compromise the seal). Reinstall the
seal into the slot of the back door of
the housing.
CAUTION: If you do not follow these
precautions whenever you use your
sport camera, the leaks can damage
or destroy your camera. The warranty
does not cover the damage caused by
user error.
EN
35