Assembly; Tighten The Belt - LiftMaster 87504-267 Manual De Instrucciones

Assembly

1 Attach the Belt Rail to the Garage Door Opener
87504-267, 84501
To avoid possible SERIOUS INJURY to finger from moving garage door opener:
•
ALWAYS keep hand clear of sprocket while operating opener.
•
Securely attach sprocket cover BEFORE operating.
To avoid SERIOUS damage to garage door opener, use ONLY those bolts/fasteners mounted in the top of
the opener.
NOTE: ONLY use the bolts removed from the garage door opener. Place the garage door opener on the packing
material to prevent scratching.
1. Models 87504-267 and 84501 Remove the two bolts from the top of the garage door opener.
2. Align the holes in the rail with the holes in the garage door opener..
3. Fasten the rail with the previously mentioned bolts. Cut away and discard the tape and Styrofoam from
around the rail.
4. Position the belt around the garage door opener sprocket.
5. Position the sprocket cover over the garage door opener sprocket and attach with hex screws.
Washered Bolt 5/16"-18x1/2"
(Mounted in the garage door opener)
Models 87504-267, 84501
HARDWARE
Hex Screw
#8x3/8"
(Packed with the
belt cover)
Hex Screw
Washered Bolt #8x3/8"
5/16"-18x1/2"

2 Tighten the Belt

1. Insert a flathead screwdriver tip into one of the nut ring slots and brace it firmly against the trolley.
2. Tighten the spring trolley nut with an adjustable wrench or a 7/16" open end wrench about a quarter turn
until the spring releases and snaps the nut ring against the trolley. This sets the spring to optimum belt
tension.
1 (To motor unit)
Spring Trolley Nut
2
Nut ring
slot
3
Nut Ring
BEFORE
AFTER RELEASE
1"
1-1/4"
(2.5 cm) (3.18 cm)
10
Nut Ring