Remote Control - LiftMaster 87504-267 Manual De Instrucciones

Abrepuertas de garaje led inteligentes
Ocultar thumbs Ver también para 87504-267:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Operation
Using the Smart Control Panel®*
SETUP
The features on the control panel can be programmed through a series of menus on the screen and the
navigation buttons. Refer to the descriptions below.
SCREEN
The main screen displays the time, temperature, and current battery charge (if applicable).
Navigation Buttons
FEATURES
Press the navigation button below "MENU" to view the Features menu.
Set the time, choose 12 or 24 hour clock and show/hide clock.
For sectional doors ONLY. Set the Timer-to-Close feature off/on
and set the time interval before door closes. NOTE: DO NOT
enable TTC if operating a one-piece door. TTC is to be used
ONLY with sectional doors.
Enable/disable lock.
Set up Wi-Fi*, add remote controls, myQ
remote button to control your garage door opener lights, or a
keyless entry.
* The garage door opener must run through a complete cycle
*If applicable
®
devices, an extra
before it will activate Wi-Fi
®
programming.
SETTINGS
Press the navigation button below the down arrow till you see TEMPERATURE to view the Settings menu.
SERVICE
Press and hold the LIGHT button, then press the second navigation button to view the Service menu.

Remote Control

Your remote control has been programmed at the factory to operate with your garage door opener.
TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL/KEYLESS ENTRY PIN
USING THE CONTROL PANEL
1.
Press the navigation button below "MENU" to view the Features menu.
2.
Use the navigation buttons to scroll to "PROGRAM".
3.
Select "REMOTE" or "KEYPAD" to program from the program menu.
4.
Remote Control: Press the button on the remote control that you wish to operate your garage door.
Keyless Entry: Enter a 4-digit personal identification number (PIN) of your choice on the keyless entry
keypad. Then press the ENTER button.
The garage door opener lights will flash (or two clicks will be heard) when the code has been programmed.
Repeat the steps above for programming additional remote controls or keyless entry devices. If programming is
unsuccessful, program the remote using the learn button.
39
Display the temperature in Fahrenheit or Celsius and
show/hide the temperature.
Select a language.
Set duration for garage door opener light to stay on after
operation, selectable range of 1-1/2 to 4-1/2 minutes. Turn the
Motion sensor off/on, and turn the entry light feature off/on.
Adjust the contrast of the screen.
Displays software version information.
Turn the Maintenance Alert (MAS) on/off.
Displays the number of remote controls, myQ
control panels, and keyless entries currently programmed
to operate the garage door opener.
Displays any errors that have occurred.
®
devices,

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

845018780284602

Tabla de contenido