Test The Safety Reversal System; Test The Protector System - LiftMaster 87504-267 Manual De Instrucciones

Adjustments

2 Test the Safety Reversal System

Without a properly installed safety reversal system, persons (particularly small children) could be
SERIOUSLY INJURED or KILLED by a closing garage door.
•
Safety reversal system MUST be tested every month.
•
After ANY adjustments are made, the safety reversal system MUST be tested. Door MUST reverse on
contact with 1-1/2" (3.8 cm) high object (or 2x4 laid flat) on the floor.
1. With the door fully open, place a 1-1/2 inch (3.8 cm) board (or a 2x4 laid flat) on the floor, centered under
the garage door.
2. Press the remote control or wall-mounted control panel to close the door. The door should stop and
reverse when it makes contact with the board. The door returns to the previous open position. Opener
beeps and lights flash 5 times.
3. If the door reverses, remove the board. The test is complete.
If the door stops but does not reverse:
1. Review the installation instructions provided to ensure all steps were followed;
2. Refer to Adjustment Step 1 and and set the down limit closer to the garage floor. NOTE: On a sectional
door, make sure adjustments do not force the door arm beyond a straight up and down position.
3. Repeat the Safety Reversal test.
If the test continues to fail, call a trained door systems technician.
1 2

3 Test the Protector System

Without a properly installed safety reversing sensor, persons (particularly small children) could be
SERIOUSLY INJURED or KILLED by a closing garage door.
The garage door opener will not close from a remote control if the sensor light beam is misaligned or
obstructed. If the garage door opener closes the door when the safety reversing sensor is obstructed (and the
sensors are no more than 6" [15 cm] above the floor), call for a trained door systems technician.
1
31
®
2