Charging The Pump Internal Battery; Filling The Sprayer - Smith XP100P Manual De Instrucciones

ENGLISH

Charging the Pump Internal Battery

1. In a dry, clean location insert the Charger Plug
into a standard electrical wall outlet. On the
end of the Pump handle (E), remove the rubber
Cover (C) to expose the Charging Port (D). Plug
the Charger Cable into the Charging Port on
the Pump. The Light (B) on the top of the Pump
should start flashing green.
a. The Pump cannot be operated while charging.
The Pump must be disconnected from the
Charger to permit further use.
b. If the Light on the Pump flashes red, the
Battery is too hot to be safely charged. This
can happen when the Battery is used heavily
in very hot weather or if the Battery is stored
in a very hot location (such as in an enclosed
vehicle or storage unit during very hot
weather). If this happens the Battery must be
allowed to cool before it can be charged.
c. If the Light on the Pump flashes red and green
alternately, this means the Battery has been
damaged and cannot be charged within the
safe charging time limit. The internal Battery
cannot be serviced, so the Pump must be
replaced.
10. Ensure the Pump and Charger are placed
where they will not be exposed to liquids, falls or
other sources of damage for the duration of the
charging period.
11. When charging is complete the Light will
remain green and stay on constantly. Charging
time will vary depending on Battery condition at
the start of charging. Charging time should not
exceed 3 hours.
12. Remove the Charger Cable from the Pump
once charging is complete. Pumps should not be
connected to the Charger during long periods of
storage. To ensure optimal Battery life the Pump
should be charged at least once every 3 months
when not in use.
13. Reinsert the rubber Cover into the Charging
Port to protect it.
14. Unplug the Charger from the electrical wall
outlet when not in use.
C
D
6

Filling the Sprayer

DANGER: RISK OF DEATH, PERSONAL INJURY
AND/OR PROPERTY DAMAGE FROM IMPROPER
CHEMICAL USE OR MIXTURE. Never use flammable
or combustible liquids, caustics, acids, or hot water
in this Sprayer. Spraying flammable or combustible
liquids can create combustible fumes that could
be ignited by the electrical system in the Sprayer,
causing an explosion. Always refer to chemical
manufacturer instructions for proper mixture. Always
wear appropriate personal protection equipment
as instructed by chemical manufacturer when
using, preparing, handling, spraying, or disposing of
chemicals. This includes at least goggles, gloves, and
protective clothing.
WARNING: Inspect the sprayer, hose, shut-off, wand,
and all connections for damage before each use.
A damaged or loose hose connection can result in
unintended exposure to the pressurized chemicals,
resulting in serious injury or property damage.
WARNING: RISK OF DAMAGE TO INTERNAL
COMPONENTS. Use of chemicals other than water
based or water soluble solutions may damage the
Sprayer and will void the warranty.
1. Ensure that the Pump is turned OFF (Light is
OFF).
2. Pull up on the knob of the Pressure Release Valve
(G) until all the pressure is released from the tank.
3. Turn the Pump handle (E) counterclockwise to
remove the pump.
4. Fill the Tank to the desired level. See volume
gradation markings markings on side of Tank.
(Always refer to chemical manufacturer for
proper mixture).
5. Install the Pump into the Tank opening and turn
clockwise until tightly sealed against the Tank.
E
G
E