FC0823W-ICA
22/12/09
8:46
Page 6
Rearward Facing Harness Adjusting - Group 0
For rearward facing the harness shoulder straps should be fitted only to the lower two sets
of slots 1 and 2 (7), with the metal plate secured to slot 3 (7).
When adjusting the height of the harness, first peel back the seat cover (4).
On the front of the seat surface you will see a metal plate in slot 3 securing the shoulder
strap to the seat back. To remove the shoulder strap pass the metal plate through the window
from front to back and then again through the window in which the harness shoulder strap
is fitted (5).
Important! Check if your child's shoulders are between two pairs of slots, always use the
first available slots level with or below the shoulder.
Refit the shoulder strap into the appropriate slot making sure the metal plate is secure in slot 3
and is flat on the front surface of the seat shell (6) (7).
Ensure the shoulder straps are not twisted or crossed over.
Ensure the friction surface on the rear of the pad is against the shoulder.
Forward Facing Harness Adjusting - Group 1
For forward facing the harness shoulder straps should be fitted only to the upper two sets
of slots 3 and 4 (7).
When adjusting the height of the harness remove the shoulder straps by passing the metal
plate found at the rear of the shell through the window from back to front (8).
Important! Check if your child's shoulders are between two pairs of slots, always use the
first available slots level with or above the shoulder.
Refit the shoulder strap into the appropriate slot making sure the metal plate is secure and flat
on the back surface of the seat shell (9).
Ensure the shoulder straps are not twisted or crossed over.
Ensure the friction surface on the rear of the pad is against the shoulder.
Harness Tension Adjusting
Tighten the harness: Pull firmly on the loose end strap below the adjuster on the shoulder
strap; it is not necessary to press on the adjuster lock (14).
Loosen the harness: Press on the adjuster button on the lower edge shoulder strap adjuster
and pull on the lower shoulder strap simultaneously (15).
Securing the Child with the Harness
Open the harness buckle by pressing firmly on the red button (E) in the centre of the
buckle (13).
Spread apart the shoulder straps to enable the child to be installed. Install your child in the
car seat, ensuring that they are seated upright against the backrest of the car seat.
6