Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
Initialization
After powering on reset, the interface will display the following:
After the initialization is complete, indicated through a progress bar, you enter the main interface, and the ON/OFF
state of online units and groups will be shown on the unit and group areas.
Function instructions
1. Mode options:
Pressing the MODE key in the main interface provides the following options in sequence:
Note: When the cursor is in the group area, the interface will show the state of the smallest unit in the group, and the
controller will adjust the mode of the smallest unit in the mode adjustment state.
2. Full control function:
When the cursor flashes under ALL, which is below the online unit display area, press the OK key to enter the full
control interface.
(1) When the online normal indoor units are controlled together, the state of the smallest indoor unit after entering the
full control function is displayed. If the smallest indoor unit is a normal indoor unit, the full control interface will be
shown as follows.
Auto
Cool
Auto
Recovery
By-pass
6
Heat
Fan
Auto
Dry
Auto
Publicidad
