What You Need; Assembly Linking Table - Extremis Walrus Instrucciones De Montaje

ASSEMBLING THE LINKING TABLE

WHAT YOU NEED

1 person
no. 17 spanner
+/- 15 min.
2. Remove the bolt, plain washers and cap nut from each backrest (at the side where you want to attach the linking
table), as shown in the figure. Keep the plain washers and cap nuts. You will need them later on in the assembly
process.
3. Place the linking table between the 2 modules with the wooden tabletop facing upwards. First attach the linking
table to the frames using 4 wood screws + M8 nuts, at positions 1 to 4. Then also attach the back of the linking table
to the back rests, at positions 5 and 6, using 2 stainless steel M8x50 bolts and the plain washers and cap nuts
removed at step 2.
4 linking table
1. Place the modules in the correct position in the definitive place where you
intend to use the sofa. Place them at least 55 cm apart.
6
5
4
1
2
3