Hoover Sprint Evo Manual Del Usuario página 5

To access the exhaust filter:
1. Unclip the exhaust grid from the rear of the cleaner. [19]
2. Separate the filter from the grid and wash the filter under warm water. [20] Do not use
hot water or detergents.
3. Remove excess water from the filter and leave to dry fully before reusing. [21]
4. Remount the filter into the grid and refit it to the cleaner.
Remember: Do not use hot water or detergents. In the unlikely event of the filters becoming
damaged, fit a Genuine Hoover consumable. Do not try and use the product without a filter
fitted.
Removing a Blockage
1. Check if the Dust Container is full. If so refer to 'Emptying The Dust Container' .
2. If the Dust Container is empty, but suction is still low;
A. Do the filters need cleaning? If so refer to 'Cleaning the washable Filters' .
B. Check if there is any other blockage in the system - Use a rod or a pole to remove any
blockage from the tubes or hose.
C. Check for and clear any blockage in the Nozzle
warning - If the cleaner is used for a significant period of time with a blockage, a thermal cut
out will switch the cleaner off to prevent overheating. The bag check indicator turn green once
the cleaner has switched off to signal that the thermal cut out has been activated. If this should
happen, switch the cleaner off, unplug and correct the fault. It will take about 45 minutes for
the cut out to automatically reset.
USER CHECKLIST
Should you have a problem with the product, complete this simple user checklist before calling
your local Hoover service.
• Is there a working electricity supply to the cleaner? Please check with another electrical
appliance.
• Is the Bag over-filled? Please refer to 'Cleaner Maintenance' .
• Is the filter blocked? Please refer to 'Cleaner Maintenance' .
• Is the hose or nozzle blocked? Please refer to 'Removing a Blockage' .
• Has the cleaner overheated? If so, it will take approximately 45 minutes to automatically
reset.
SprintEvoManual__1-3_union.indd 3
IMPORTANT INFORMATION
hoover Spares and Consumables
Always replace parts with genuine Hoover spares. These are available from your local Hoover
dealer or direct from Hoover. when ordering parts always quote your model number.
CONSUMABLES
• Filter kit:
(Hepa pre-motor filter+ protective mesh and exhaust filter)
SPARES:
• Complete Flexible hose:
• Carpet & Floor nozzle:
• Mini Turbo nozzle:
• Hard Floor nozzle:
Quality
Hoover's factories have been independently assessed for quality. Our products are made using
a quality system which meets the requirements of ISO 9001.
The Environment:
This appliance is marked according to the European Directive 2002/96/EC on waste Electrical
and Electronic Equipment (wEEE). By ensuring this product is disposed of correctly you will help
prevent potential negative consequences for the environment and human health, which could
otherwise be caused by inappropriate waste handling of this product.
The symbol on the product indicates that this product may not be treated as
houshold waste. Instead it shall be handed over to the appliance collection point
for recycling of electrical and electronic equipment. Disposal must be carried out
in accordance with the local environmental regulations for waste disposal. For
more detailed information about treatment, recovery and recycling of this product,
please contact your local city office, your household waste disposal service or the
shop where you purchased the product.
Your Guarantee
The guarantee conditions for this appliance are as defined by our representative in the country
in which it is sold. Details regarding these conditions can be obtained from the dealer from
whom the appliance was purchased. The bill of sale or receipt must be produced when making
any claim under the terms of this guarantee.
Subject to change without notice.
3
GB
U66, 35601328
D108,35601329
G82,35600417
J20, 09200356
G87PC, 35600655
25/07/2012 13.49.55